Using the remote control
CD/DVD |
|
Ensure that DVD mode is selected using the CD/DVD toggle button. The ‘DVD’ LED above the CD/DVD button is lit briefly when DVD mode is selected.
DISP (display)
Dims or turns the DV88PLUS’s display on or off. Turning the display off generally gives a slight improvement in sound quality.
Pressing DISP once turns the display off; twice dims the display. To restore the display to full brightness, press DISP a third time.
This button enables you to repeat a selected section from the disc (see page 12).
RPT (repeat)
Press RPT to cycle through the repeat play options.
This allows direct access to individual tracks on audio CDs. To select a track, press the corresponding keypad button followed by OK. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press 1, then 5, then OK.
|
|
|
|
|
|
|
|
|
|
|
| Standby |
| ||
|
|
|
|
|
|
|
|
|
|
|
| Press Standby to toggle the standby state of the DVD player. | |||
| CD/DVD REMOTE |
|
|
|
|
| Note that Arcam CD players are not controlled by this button. | ||||||||
CD DVD |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CD |
|
|
|
|
|
|
|
|
|
|
| CLEAR | |||
1 | 2 | 3 |
|
|
|
|
|
|
|
| |||||
DVD |
|
|
|
| Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear | ||||||||||
| 4 | 5 | 6 |
|
|
|
| a numeric field (see pages | |||||||
DISP |
|
|
|
|
|
|
|
| |||||||
| 7 | 8 | 9 |
|
|
|
| PROG (program) | |||||||
|
|
|
| You can program a | selection of up to 20 chapters/tracks | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
| from a disc to play in any order. Press PROG to access the | |||
|
|
|
|
|
| 0 |
|
|
|
|
| ||||
RPT |
|
| CLEAR | PROG |
|
| ’Programme’ menu (see pages 13 and 15). | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fast play and Skip chapter/tracks
Play fast (
) and Skip ( 
) chapters/tracks in both directions (see page 9).
OPEN
Opens and closes the disc tray.
OPENOK
Slow play
Press 
or 
on the remote control to play slow forward or backwards. There are four speeds of slow playback: 1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle through the different speeds. To resume normal playback speed, press PLAY.
Note that slow play does not apply to audio CDs.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and menu pages. Confirm your selection with the OK button.
Playback control
Pause (
), Play (
) and Stop (
) (see page 9).
Advanced controls
These buttons are described on the facing page.
MUTE
P | SUBT | TITLE | MENU | |
MODE | ||||
|
|
|
ZOOM AUDIO MEM RTN
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
Volume +/–
Adjusts the volume on Arcam
Note that the volume
ANGLE SETUP STATUS SRCH
DV88PLUS
10
NOTE: Remember to install the two AAA batteries supplied before trying to use your remote control.
Do not place anything in front of the display area on the DVD player (where the IR receiver is located), or the remote control may not work.