WATCHING A DVD ON YOUR TV
After all the connections have been done, please follow steps below to watch a DVD on your TV. 1 Make sure all the products are plugged back into the AC (mains) power.
2 Press the set OPEN button and lift the LCD screen.
3 Slide the DVD player’s POWER switch to the ON position, the DVD logo
4 Turn on your TV and set it to DVD mode (please see box below), the DVD logo will appear on your TV’s screen.
5 Press the OPEN button on the DVD player to open the disc door. Place a disc gently on the tray with the label side up and close the door by pushing it down. The DVD player starts to read the disc’s table of contents (this may take a few seconds).
6 Some discs will start playing automatically, and others will display the Disc Contents Menu on the screen. If the menu is presented, use the 
, 
, 
& 
buttons to highlight your selection and press OK button to confirm.
7 Press the VOLUME + or VOLUME – button on DVD’s remote and on your TV’s remote to adjust the volume level.
8 Fold down the LCD screen cover, the DVD player will continue to work, but the screen will be dark.
9 | To stop playback, press the STOP button. |
|
|
|
|
|
|
|
| ||||||||
10 | To pause the playback, press the OK button |
|
|
|
|
|
|
| on the remote. To resume playback, | ||||||||
|
|
|
| ||||||||||||||
|
|
|
| ||||||||||||||
| press the OK button |
|
|
|
|
|
|
| again. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||
NOTE 1: During play, press the STOP button once, the display will show “ PRE STOP 
”. If you press the STOP button the second time, the display will show “ STOP 
”, and now your system is in the full STOP mode.
NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same as during normal play.
11 To skip to another track/chapter, press the NEXT 
or PREVIOUS 
button repeatedly during playback.
12 To access the disc menu or title menu during DVD play, press the MENU or TITLE button on the remote control.
13 If you want to use other DVD play functions, please see pages
14 Remember to shut off the player by sliding the POWER switch to the OFF position when the movie finishes playing.
How to Find your TV’s Video Input Channel
Make sure you have made all the connections (see page 17), you may need to change your TV’s video input mode to see the DVD player’s menu and movies, also double check that both TV and player are powered from the mains (AC power).
1.Set your TV to the correct video input. For example, if you connect this player to the VIDEO 1 input on your TV, switch your TV to video 1.
2.Switch your TV to the correct video input channel. The video input channel varies with different TV brands and models, many TV remote controls have a TV/VIDEO button which can be used to change to different video inputs and back to TV for normal broadcast viewing, on some older TVs, you may need to press channel 3 on your TV’s remote. Once you selected the correct channel, your TV will show the opening DVD screen. For more details, please see your TV’s manual.
19 |
4/3/2006, 9:24 AM