Laser STB-HDM2000 user manual First time installation, System Setup

Page 6

STB-HDM2000 User Manual

First time installation

Start channel installation.

For first time use, the automatic installation message will appear on screen.

a.Select the menu display language.

b.Select the reception country.

c.Then, select your time zone .

d.Please keep the LCN (Logical Channel Number) option ON (activated), so that the channels can be classified in the correct order.

e.Press the Start button to begin the channel search. The DVB-T channel search starts immediately and will only take a few minutes

System Setup

Press [Menu] key to access:

OSD Language

Use this item to select the language of the setup menu and screen display.

Country

Australia is the correct default setting.

LCN (Logical Channel Number)

Used to classify DVB-T channels in the predefined order. In most of the countries, including Australia, this option must be enabled.

Time Zone

In this menu adjust the time zone to NSW/ACT+10:00, VIC+10:00, QLD+10:00, SA+9:30,WA+8:00, TAS+10:00,NT+9:30

Parental Control

Select Parental Control to set a block based on program ratings. Highlight Parental Control and press OK. A PIN CODE Dialogue box will be displayed, enter your PIN (default code is “0000”) and press OK. Once in the Parental Control sub-menu use

6

Image 6
Contents STB-HDM2000 Important safety instructions Please read carefully and keep for future referenceTable of Contents IntroductionFront Panel and Rear Panel Front PanelRear Panel Remote Controller First time installation System SetupVideo Setting Audio LR Mode Audio SettingDisplay problem in Hdmi mode Screen RatioFavourites MenusRecording and program reminder Record live TVSchedule record / Reminder Trouble shooting STB-HDM2000