I N S T A L L AT I O N
5
Connect another cable between the other OUT terminal on the splitter and the
6
Connect the last coaxial cable between the OUT terminal on the RF (A/B) switch and the VHF/UHF terminal on the rear of the TV.
After you’ve made this connection, set the A/B switch to the “A” position for normal view- ing. Set the A/B switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B,” you will need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions on pages
1 |
Connect a coaxial cable between the ANTENNA OUT terminal on the VCR and the antenna terminal on the TV.
A coaxial cable is usually included with a VCR. (If not, check your local electronics store).
2
Connect a set of video/audio cables between the VIDEO/AUDIO OUT jacks on the VCR and the VIDEO/AUDIO jacks on the TV.
If you have a mono VCR, connect L(mono) to VCR audio out using only one audio cable.
Follow the instructions in “Viewing a VCR or Camcorder Tape” on page 3.12 to view your VCR tape.
2.4 CHAPTER TWO: INSTALLATION