Samsung DVD-V4800 instruction manual Set Digital Output, Set DTS

Digital Output DTS

If your A/V receiver is equipped with a Dolby Digital decoder, your DVD-VCR can output Dolby Digital 5.1 sound, but you MUST enable this feature in the menu system to prevent damage to your speakers.

NOTE: Select “Bitstream” ONLY if you have connected a Dolby Digital-equipped A/V receiver to the Digital Output (coaxial) on the DVD-VCR rear panel.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “Digital Output”

Highlight “Digital Output” then press the RIGHT button to select one of the following options:

•PCM – To use your DVD with an A/V receiver without a Dolby Digital decoder.

•Bitstream –To use your DVD with an A/V receiver with a Dolby Digital decoder.

PCM

Bitstream

PCM Down Sampling : On

If your A/V receiver is equipped with a DTS decoder, your DVD-VCR can output DTS digital sound, but you MUST enable this feature in the menu system.

NOTE: Select “On” ONLY if you have connected a DTS-equipped A/V receiver to the Digital audio Out (coaxial) on the DVD-VCR rear panel.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “DTS”

Highlight “DTS” then press the RIGHT button to select one of the following options:

•Off – To use your DVD with an A/V receiver NOT equipped with a DTS decoder.

•On – To use your DVD with an A/V receiver equipped with a DTS decoder

Off

On

PCM Down Sampling : On

ENG-18