Variable Search System | Basic Recording |
When a program is recorded, the starting point is given an Index mark for easy location. However, the VHS Index Search System (VISS) cannot recognize index marks made by old VCRs. If the VCR has trouble finding a mark, it is probably because the cassette was recorded on a VCR without VISS. If you want to index two programs in a row, set your VCR to stop, then start recording each program.
Forward 
Reverse 
Go to [0:00:00] stop
Use this feature when you want to search for [0:00:00] counter position on a cassette. Press the CLEAR button at the point where you want to set the counter to [0:00:00].
1.Press the SEARCH button to display the search screen.
2.Use the UP/DOWN buttons to select Go to [0:00:00] and press ENTER or RIGHT button.
3.The VCR will rewind or fast forward, searching for the [0:00:00] counter position, and then automatically stop at that position.
End search
Use this feature when you want to search for a blank position to record a program.
1.Press the SEARCH button to display the search screen.
2.Use the UP/DOWN buttons to select End Search and press ENTER or RIGHT button.
3.The VCR will fast forward, searching for a blank position and then automatically stop at that position.
Intro Scan(Forward/Reverse)
Use this feature when you don’t know exactly where a recorded program is located on a cassette
tape.
1.Press the SEARCH button to display the search screen.
2.Use the UP/DOWN buttons to select Forward/ Reverse Intro Scan and press ENTER or RIGHT button.
3.When an index mark is found, DVD – VCR will playback the tape for 5 seconds, after which it will continue searching for next index mark.
4. If you want to watch from a particular index, simply press ll.
You can record a TV show in progress by inserting a blank tape and pressing the z(REC) button. You can even add time in
NOTE: Be sure your videotape has a Record Safety Tab. If the tab is missing, you can cover the opening with a small piece of tape. Warning: Do not cover this opening unless you are sure you want to record over the tape.
Before You Begin...
•Power on the DVD-VCR
•Power on the TV
1Insert Tape
Insert a blank VHS tape into the VCR deck.
•Make sure the tape is long enough to record the entire program.
To change the Recording Speed, see page 32.
2Select a Channel to Record
Use the
3Start Recording
Press the z(REC) button on the remote control or front panel.
4Pause/Resume Recording
Press the ll(PLAY/PAUSE) button. Press z(REC) again to resume.
5Stop Recording
Press the (STOP) button.
For options while recording is in progress, see “Special Recording Features”.
➢Recording from the DVD player to the VCR is not possible.