KS1_01818B_01_ENG_UMG 12/10/02 12:27 PM Page 10
Plug & Play Feature
ENG
When the television is initially powered ON, three basic customer settings proceed automatically and subsequently: setting the language, channel and clock.
Plug & Play
Ant. Input Check
Auto Store | Exit |
P 1 |
|
|
471 | MHz | 48 % |
Exit
|
|
|
|
| Time |
|
|
| Clock | - |
|
|
|
|
|
|
|
|
|
| Move | Exit |
|
|
|
|
|
ENJOY YOUR WATCHING
|
|
|
| Function |
|
| Language : English | ||
|
| |||
|
| Time |
| |
|
| Plug & Play |
| |
|
| Blue Screen | : Off | |
|
| Child Lock |
| |
|
| Low Noise AMP | : Off | |
|
|
|
|
|
1If the television is in Standby mode, press the POWER
button on the remote control.
Result: The message “Plug & Play” is displayed. It flickers for a little while and then the “Language” menu is automatically displayed.
2Press the ▲ or ▼ button to select required language. Press the MENU button to enter the language, and then the message “Ant. Input Check” is displayed.
➣If any language is not selected on the “Language” menu, the “Language” menu will be displayed about 30 seconds later.
3Make sure that the antenna is connected to the TV. And then press the + or – button to store the channels (refer to “Storing the Channels Automatically” on page 12).
Result: The horizontal bar is displayed, and then channels are stored in an order which reflects their positions in the frequency range.
4When searching and storing is complete, the “Time” menu is displayed.
5Press the + or – button to move to the hour or minute. Set the hour or minute by pressing the ▲ or ▼ button (refer to “Setting and Displaying the Current Time” on page 23).
6When you have finished, press the MENU button.
Result: The message “ENJOY YOUR WATCHING” is displayed, and then the channel which has been stored will be activated.
7If you want to reset this feature...
1 Press the MENU button.
2 Press the ▲ or ▼ button to select the “Function”, and then press the + or – button.
3 Select the “Plug & Play” by pressing the ▲ or ▼ button, and then press the + or – button.
Result: The message “Plug & Play” is displayed.
Select | Enter | Exit |
10