Samsung DVD-R119 instruction manual Set time depending on disc status, Mode Recording Mode

•Start/End Time : Start and end time of the timer recording.

•Mode (Recording Mode) :

-Auto : Select when you want to set video quality automatically. In Auto mode, the most suitable record mode is adjusted automatically, according to remaining time on the disc and length of the timer recording. This function is selected only one mode in XP, SP, LP and EP modes.

-XP (high quality) : Select when video quality is important.

-SP (standard quality) : Select to record in standard quality.

-LP (low quality) : Select when a long recording time is required.

-EP (extended) : Select when a longer recording time is required.

■ When you are recording at EP mode on a

NOTE	DVD-RW(V mode)/-R disc, it may not
	record the full 6 or 8 hours because the
	unit uses the VBR(Variable Bit Rate)
	ENCODING system. For example, if you
	record a programme with a lot of action,
	it uses a higher bit rate which in turn
	consumes more disc memory.

•PDC : PDC(Programme Delivery Control) function.

-If you set this function on, you can control the starting and ending time of recording by special signal included in the broadcasting signal. If a TV programme is shortened or starts earlier or later than scheduled, this function synchronizes the starting and ending time of recording with the actual broadcasting time automatically.

-Set up the start-time EXACTLY according to the published TV schedule. Otherwise the timer recording will not operates.

-Do not select PDC unless you are sure the programme you wish to record is broadcast with PDC.

•TITLE :To label the title name, select the title and then press the OK button. Title renaming screen appears.

See page 77 for the registration.

4 After selecting the set up value for each mode, press the OK button to select Save, and press the OK button again.

If the timer settings overlap;

The programmes are recorded in order of priority. If timer recording is set for the first programme and then again for the second programme and both programmes overlap, the following message will appear on the screen: “This setting is identical with 1.” The message shows that the first programme has priority. After recording of the first programme is complete, the second programme starts being recorded.

To exit without saving the current setting Press the MENU button.

To return to the previous menu

Press the RETURN button if you don’t want to set a timer recording.

5	Turn the power off to finish the Timer Recording
	setting.
	•	will appear on the front panel. It means that a
		timer recording is registered.

Timer Recording will not work when the power is on.

	■	The timer recording time may differ from the
		set time depending on disc status and
NOTE
		overall timer recording status (for example,
		recording times overlapping, or when the
		previous recording ends within 2 minutes
		before the start time of the next recording.)

■You can make the Timer Recording up to 12 programmes.

Recording

English - 73