Samsung CHT-420 instruction manual Safety Instructions

Page 2
Electric Service Equipment
Antenna Lead-in Wire
Ground Clamp
Antenna Discharge Unit
(NEC Section 810-20)
Grounding Conductors
(NEC Section 810-21)
Grounding Clamps
Power Service Grounding Electrode System (NEC Section 810-21)
NEC-NATIONAL ELECTRICAL CODE

Safety Instructions

Safety Instructions

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product.

This symbol alerts you that important literature concerning operation and maintenance has been included with this product.

10.

Ventilation-Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it

 

from overheating. These openings must not be blocked or covered. The openings should never be blocked by placing the product on a

 

bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper

 

ventilation is provided or the manufacturer’s instructions have been adhered to.

11.

Power Sources-This product should be operated only from the type of power source indicated on the marking label. If you are not sure of

 

the type of power supplied to your home, consult your product dealer or local power company. For products intended to operate from

 

battery power, or other sources, refer to the operating instructions.

12.

Grounding or Polarization-This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider

 

than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the

 

outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety

 

purpose of the polarized plug.

Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

Caution: FCC regulations state that any unauthorized changes or modifications to this equipment may void the user's authority to operate it.

Caution: To prevent electric shock, match wide blade of plug to wide slot, fully insert.

Attention: Pour eviter les chocs electriques, introduire la lame le plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’au fond.

Important: One Federal Court has held that unauthorized recording of copyrighted TV programs is an infringement of U.S. copyright laws.

Certain Canadian programs may be copyrighted and any unauthorized recording in whole or in part may be a violation of these rights.

To prevent damage which may result in fire or electric shock hazard,

do not expose this appliance to rain or moisture.

Important Safety Instructions

1.Read Instructions-All the safety and operating instructions should be read before the product is operated.

2.Retain Instructions-The safety and operating instructions should be retained for future reference.

3.Heed Warnings-All warnings on the product and in the operating instructions should be adhered to.

4.Follow Instructions-All operating and using instructions should be followed.

5.Cleaning-Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

6.Attachments-Do not use attachments not recommended by the product manufacturer as they may cause hazards.

7.Water and Moisture-Do not use this product near water-for example near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like.

8.Accessories-Do not place this product on an unstable cart, stand, tripod, bracket, or table.The product may fall,

causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with the product. Any mounting of the product should follow the manufacturer’s instructions and should use a mounting accessory recommended by the manufacturer.

9.A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn.

2

13.

Alternate Warnings -This produck is equipped with a three-wire grounding-type plug, a plug having a third (grounding) pin.

 

This plug will only fit into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety

 

purpose of the grounding-type plug.

14.

Power-CordProtection-Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon

 

or against them, paying particular attention to cords at plugs, convenience receptacles,

and the point where they exit from the product.

15. Outdoor Antenna Grounding-If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA 70 provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

16.Lightning-For added protection for this product during a lightning storm or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.

17.Power Lines-An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

18.Overloading-Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.

19.Object and Liquid Entry-Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

20.Servicing-Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

21.Damage Requiring Service-Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a When the power-supply cord or plug is damaged.

b If liquid has been spilled or objects have fallen into the product. c If the product has been exposed to rain or water.

d If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e If the product has been dropped or damaged in any way.

f When the product exhibits a distinct change in performance-this indicates a need for service.

22.Replacement Parts-When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part.Unauthorized substitutions may result in fire, electric shock, or other hazards.

23.Safety check-Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

24.Heat-The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

25.Wall or Ceiling Mounting The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

3

Image 2
Contents CHT-420 Safety Instructions Table of Contents Feature Summary UnpackingFront Panel Display With Volume Dial, you can adjust the volume onFront Panel Overview Speakers or HeadphoneANGLE, 100+ Rear Panel Remote Control OverviewInsert Remote Control Batteries Line in 1Connect DVD-VCR to TV Brand CodesConnect Antenna/Cable to DVD-VCR RF ConnectionBasic TV Tuner Operations Deck Control Buttons Basic VHS PlaybackBasic DVD Playback On-Screen Menu Navigation Clock Setup Menu LanguageManual Clock Set Tuner Band Setting Select Channel add/delete Auto Channel Memory Channel Add/DeleteRun Auto channel memory Select Channel to add/deleteRF Output Channel Auto Power Off Front Panel DimmerDisc Menu Language Subtitle Language Audio LanguageParental Dynamic Compression TV Aspect Ratio Black Level Alt Video OutSpecial Playback Features Disc Menu Navigation Screen Fit PlaybackTitle/Chapter/Time Selection Zoom AngleSubtitle Repeat Repeat Chapter/Title Bookmarks AudioProgrammed Playback CD MP3 Playback Random Playback CDVHS Playback Special VCR Playback Features Auto PlayTracking Adjusting Picture Alignment Automatically Variable Search System Basic Recording Special Recording Features One-Touch Recording OTR Record SpeedSet Time/Date/Speed Save Timer RecordingSelect Channel Number Auto Speed SelectAM antenna connections Connecting the FM and AM antennas Connecting the SpeakersFM antenna connections Cooling fanVolume light Speaker setup Speaker Volume ControlSpeaker setup Dolby Pro Logic II decoder To adjust the speaker balancePresetting stations Sound mode/effect function Listening to radio broadcastsMonitor TV Connections Connecting Other Video Equipment Outputs Technical SpecificationsInputs Samsung Combination DVD & VCR