Network Connection - Wired
There are two main ways to connect your TV to your network using cable, depending on your network setup. They are illustrated below:
The Modem Port on the Wall | External Modem | TV Rear Panel |
| ||
| (ADSL / VDSL / Cable TV) |
|
Modem Cable |
| LAN Cable |
The LAN Port on the Wall | TV Rear Panel |
| LAN Cable |
✎✎A network speed of lower than 10 Mbps is not supported.
Configuring the Network Connection - Wired
Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to access the Internet so you don’t have to enter them manually.
To configure your network connection for a network that uses DHCP, follow these steps:
1.Connect your TV to your network as shown in one of the illustrations above.
2.Turn on your TV, press the MENU button on your remote, and then select the Network → Network Settings.
3.Select Wired.
4.The network connection screen appears and verifies the network connection. When the connection has been verified, the “Internet is connected successfully.” message appears.
✎✎If your TV cannot acquire network the connection values
automatically or if you want to set up the connection manually, select IP Settings on the network connection screen. Set IP Mode to Manual. You must enter the IP Address, Subnet Mask, Gateway, and DNS Server manually.
IP Mode
IP Address
Subnet Mask
Gateway
DNS Mode
DNS Server
IP Settings
Manual ►
. 
. 
. 
. 
. 
. 
. 
. 
. 
Manual
. 
. 
. 
OK
U Move EEnter R Return
✎✎For the detailed information, refer to “Network Settings” in the
English - 13