Samsung UN46ES6580 Configuring Network Connections, Configuring a Wireless Network Connection

Configuring Network Connections

After you have run the initial setup, you can configure or reconfigure the network connections through the TV'smenu.

Configuring a Wireless Network Connection

The instructions below are for networks that use the Dynamic Host Configuration configure network connections automatically. Most wireless networks use DHCP. network, see the e-Manual for configuration instructions.

Protocol (DHCP) to If you have a Static

IP

To configure the network connection

for a network that

uses

DHCP,

follow these steps:

1. 2.

Connect your TV

Turn on your TV, Settings)

to your network as shown in the illustration on page and then go to the Network Settings screen. (Menu

15.

-Network

-->

Network

3.

4.

5.

Select Start. The Network function searches for available wireless networks. When done, it displays a
list of the available networks.
In the list of networks, move the highlight to select a network, and then select Next.
~ If you have a WPS(PBC) compatible router, select WPS(PBC) instead, and then follow the
directions on the screen.
Enter your network security key or WPS PIN using your remote.
~ Enter numbers and letters using your remote.
•	Enter numbers by pressing the number buttons on your remote.

6. 7.

	•	To enter a letter, move the Highlight to the letter, and then select it. You can enter numbers in
		the same fashion if you choose.
~	To display capital letters (or redisplay small letters if capital letters are displayed), select Caps or
	Shift.
~	To display symbols and punctuation, select * ·To redisplay letters, select *		again.
When done, select Next if you have entered a security key or WPS PIN if you have entered a WPS PIN.
The TV checks the wireless connection. If the connection is successful, the "You are connected to the
Internet. If you have any problems using online services, please contact your Internet Service
Provider." message appears. Select Next using your remote.
~	For more detailed information, see "Setting up the Wireless Network" in thee-Manual.
~	If you want to configure the connection manually, select IP Settings on the Network Connection
	screen. Set IP Setting to Enter manually, and then enter the IP Address, Subnet Mask,
	Gateway, and DNS Server manually.