Samsung 460DX, 400DX Off, Coarse, Fine, Direct button on the remote control is the Auto button

Note

• If you adjust the picture by using the Custom function, Color Tone will turn to the Cusome mode.

Color Temp

[MENU] → [∧ / ∨] → [ENTER] → [∧ / ∨] → [ENTER] → [< / >] → [ENTER]

Color Temp is a measure of the 'warmth' of the image colors. (This function is only enabled if the Color Tone is set to Off.)

Brightness Sensor

[MENU] → [∧ / ∨] → [ENTER] → [∧ / ∨] → [ENTER] → [< / >] → [ENTER]

Brightness Sensor is to automatically detect distribution of inputted visual signal and adjust to create optimum brightness.

1)On

2)Off

Image Lock

Image Lock is used to fine-tune and get the best image by removing noise that creates unstable images with jitters and shakiness. If satisfactory results are not obtained using the Fine adjustment, use the Coarse adjustment and then use Fine again.

(Available in PC, BNC mode only)

1)Coarse

[MENU] → [∧ / ∨] → [ENTER] → [∧ / ∨] → [ENTER] → [ENTER] → [< / >] → [ENTER]

Removes noise such as vertical stripes. Coarse adjustment may move the screen image area. You may relocate it to the center using the horizontal control menu.

2)Fine

[MENU] → [∧ / ∨] → [ENTER] → [∧ / ∨] → [ENTER] → [∧ / ∨] →[ENTER] → [< / >] → [ENTER] Removes noise such as horizontal stripes. If the noise persists even after fine tuning, repeat it after adjusting the frequency (clock speed).

3)Position

[MENU] → [∧ / ∨] → [ENTER] → [∧ / ∨] → [ENTER] → [∧ / ∨] →[ENTER] → [< / >] / [∧ / ∨]→ [ENTER]

Adjusts the screen location horizontally and vertically.

Auto Adjustment

[MENU] → [∧ / ∨] → [ENTER] → [∧ / ∨] → [ENTER]

The values of Fine, Coarse, Position are adjusted automatically.

By changing the resolution in the control panel, the auto function is performed.

(Available in PC, BNC mode only)

[The direct button on the remote control is the 'AUTO' button.]

Signal Balance

This is used to make up for the weak RGB signal transmitted by a long signal cable.

(Available in PC, BNC mode only)