DSB-4700F
OPERATING THE RECEIVER
TROUBLESHOOTING
DSB-4700F
4.7 Copy Channel Data
If you want to copy the channel data from one receiver to another, please follow the instruction below.
Please make your own channel data, such as favorite & lock channel with your own master box.
Then take your master box when you install another box.
1.Plug on both master & slave receivers
2.Master Box(Installed Box) :
3.Slave Box(Installing Box) : Menu Mode
4.Connect 2 Boxes with RS232 serial cable
(Both end should have male connector with crossed signals)
5.Select the ‘System Setup’ and press the OK key.
6.Select the ‘Copy Channel Data’ with the / keys.
7.Press ‘OK’ to start channel data copy
Problem | Possible cause | Solution of the problem |
|
|
|
No display LED on | Power cord | Power cord plug in correctly |
the front panel; | not plugged in correctly |
|
No power supply |
|
|
|
|
|
No pictures on the screen | Receiver in Standby mode; | Set receiver to “On”; |
| RCA not connected tightly | Check connection and correct; |
| to video output of television; |
|
| incorrect channel or video | Check channel and video output and |
| output selected on television | correct (TV instruction manual) |
|
|
|
No sound | Audio cord connected | Check connection and correct; |
| incorrectly; |
|
| Loudness level = 0; | Increase loudness on television set; |
| Muting active | Press the MUTE key |
|
|
|
Remote Control does not | incorrect operation; | Point remote control |
operate directly |
| towards the Receiver. |
| Batteries dead or inserted | Replace batteries or insert correctly |
| incorrectly |
|
|
|
|
Poor picture quality | Signal strength to low | Check all wire connections. Check the |
signal strength in |
| the “Auto Scanning” menu, correct |
|
| alignment of your antenna |
|
|
|
Antenna cable not connected | Check connection and correct; | |
“Searching for signal” | or not tight; |
|
| LNB defective; | Change LNB; |
| incorrect position of the | Check position and correct, |
| satellite antenna; | Check the signal strength in |
| LNB is set to "OFF" in | the “Auto Scanning” menu |
| LNB Setting menu |
|
|
|
|
Satellite not yet set | Scan of in “Auto scanning” | |
“Channel data |
| or “Manual scanning” menu |
does not exist.” |
|
|
|
|
|
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of with household refuse. Please obtain appropriate information about the regulations in your community, and dispose of all refuse in accordance with regulations at the separate locations provided.
34 | D I G I T A L | S A T E L L I T E | R E C E I V E R | 35 |