Description

FrontPanel

DESCRIPTION

	1		2	3	4	5	6
1.		/ I	This key is for turning the receiver on and Standby.


2.	OK		This key is for entering and confirming any data to the receiver in the
			menu system. This key is for selecting the item. Press while viewing
			TV and a list of channels is displayed.
3.	… , †		These keys are for changing the channels during watching TV and for
			moving the highlight bar for selecting options on the menu.
4.	œ , √		These keys are for increasing and decreasing the volume level manually
			during watching TV and for moving the highlight bar for selecting options
			on the menu.

5.7 Segment Display This LED display will show the current channel number.

While the receiver is in Standby mode, the display will show the current time.

6.Infrared Sensor This is to receive the IR commands from the Remote Control Unit.

1.	AC MAINS	This is to plug in the AC mains power cord.
		The input AC voltage range is 120V, 60Hz supply.
2.	DISH INPUT	This port is to connect the coaxial cable from LNB of your dish.
		The IF input is provided through this port and the input frequency
		range is 950-2150 MHz. Also the voltage switching 13V and
		18V is passed through this port.

3.RS 232 DATA PORT This is used to connect your receiver to a computer for reading and loading data information. (only for service)

4. LOOP	To enable the connection of an Analog receiver,
	The receiver is provided with this ‘LOOP’ port.

5.S-VIDEO OUT This is used to connect STB to your TV by using S-VHS cable.

6.	0/12V	This is used to connect to an external LNB switch.
7.	AV OUT	These RCA connectors are used to connect any external
		video and audio.
8.	RF OUT	This is used to connect to your TV via RF cable.
		(Preset to channel 3)
9.	ANT. IN	This is used to connect your local RF channels to
		your TV through Loop.

D I G I T A L

S A T E L L I T E

R E C E I V E R

DESCRIPTION