AV-EXpertManual.qxd 7/12/07 6:41 PM Page 18
IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over.
STEP 2: Press the component button you want to turn on and then the POWER button; repeat for all other components in the order you want them to turn on. The component LED lights will blink once each time you press the POWER button.
POWER
COMPONENT
BUTTONS
STEP 3: Once you’ve entered all the Power On commands, press the CHANNEL UP 
button to save your MacroPower commands. The component LED lights will blink three times to confirm that the programming has been successfully saved.
CHANNEL
UP 
SUGGESTION: Most of the components have the same signal to turn the power On and Off. You may want to program MacroPower only in the POWER button and save the System Off button to turn components On or Off individually.
Note: If you want to program MacroPower for the SYSTEM OFF button, repeat the same steps used for Power ON programming.
Page 18