Welcome
SETUP
SETUP
SETUP
SETUP
Other Info
General
Problem | Possible Remedies | |
How to reset TV to | ❏ | Turn on the TV. While holding down the RESET button on the remote |
factory settings |
| control, press the POWER button on the TV. (The TV will turn itself off, then |
|
| back on again.) Release the RESET button. |
|
| |
How to restore Video settings ❏ | Press the RESET button on the remote control while in the Video Menu (see | |
to factory settings |
| page 72). |
How to restore Audio | ❏ | Press the RESET button on the remote control while in the Audio Menu (see |
settings to factory settings |
| page 74). |
|
|
|
Cannot cycle through the | ❏ | Be sure the Video Label option is not set to Skip (see page 84). |
other video equipment |
|
|
connected to the TV |
|
|
|
|
|
Cannot operate Menu | ❏ | If a menu option appears in gray, this indicates that the TV is in a state in |
|
| which the menu option is not available. |
|
|
|
Lost password | ❏ | In the password screen (see page 80), enter the following master password: |
|
| 4357. The master password clears your previous password; it cannot be |
|
| used to temporarily unblock channels. |
LED on front panel is lit | ❏ | The STAND BY LED (see page 14) blinks when the TV is turned on, then |
|
| shuts off when the picture is displayed. If the LED blinks continuously, this |
|
| may indicate the TV needs service. |
| ❏ | The TIMER LED (see page 14) indicates that the timer is set. When the |
|
| timer is set, this LED will remain lit even when the TV is turned off. |
|
|
|
94