Using Your Remote, Controlling Combo Devices

Using Your Remote

Controlling Devices with Separate Power On and Off Buttons

Some GE, RCA and ProScan models require you to press the device button for more than one second to turn the device on and the POWER button to turn the device off.

Controlling Combo Devices

Some Combo devices (e.g., TV/DVR, TV/DVD, DVD/DVR, etc.) will require you to set up two different Mode buttons to control both parts of the Combo device. For example, if you have a TV/ DVD Combo, you might need to set up one code under the TV button to control the TV part AND a separate code (under any other Mode button) to control the DVD part.

DVR/DVD Punch-Through

This remote allows the 6 DVD/VCR transport buttons (i.e. PLAY, PAUSE, STOP, FF, REWIND, and REC) to Punch-through from any Mode programmed with TV, SAT or Cable codes to the last DVD, or VCR programmed Mode you used, i.e., the transport keys control your DVD or VCR player even when you are in TV, SAT or Cable mode. If you use a SAT/DVR, Cable/DVR, etc., you may want to disable this Punch-through feature

to allow the transport keys to control your DVR device. The following steps will disable the punch- through feature:

1.Press and hold SETUP until the red indicator stays on, then release the SETUP button.

2.Press and hold PAUSE until the red indicator turns off, then release the PAUSE button. The

PAUSE button needs to be held held for about 3 seconds before the red indicator turns off.

The punch-through feature can be enabled again by repeating the above steps.