Code Search

If your device does not respond after you have tried all the codes for your brand, or if your brand is not listed, try searching for your code by following these steps.

1.Manually turn on the device (TV, DVD, etc.) to be controlled.

2. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.

3. Press and quickly release the desired mode button (TV, DVD, etc.). The red indicator blinks off once.

4. Press the CHAN+ button

repeatedly (up to 300 times) until the device to be controlled changes channel. The red

indicator blinks off with each

button press. If you accidentally overshoot the code required, press the CHAN- button to backtrack through the library until the device changes channel. Pressing CHAN+ changes direction to forward again.

5. Press and release ENTER to install the code.

Most users will store DVD codes under the DVD button, and Satellite or Cable codes under SAT/CBL. If (for ex- ample) you want to store a DVR code under SAT/CBL, first follow the procedure for Direct Code Entry (page

8)and press SAT/CBL in step 2 of Direct Code Entry, then enter ANY DVR code in step 3 of Direct Code Entry. Then follow the steps above for Code Search.

Note: If the device does not have a CHAN+ button, use PLAY (DVD/DVR/VCR only) or POWER instead. Code Search starts from the currently stored 4 digit number under that mode. Sometimes the first code that “works” with your device may only allow limited functionality (e.g., the MENU button might not work). There may be a code that performs more functions. Continue the code

search process until the best code is found.