Operations
Projecting the picture
LAMP STANDBY
Power switch
VOLUME(green)
MENU
ENTER
INPUT SELECT
MUTING DISPLAY POWER
2 Turn on the power of the connected equipment.
3 Press RGB or VIDEO to select the input you want to watch.
The selected input indication is displayed on the screen.
To watch a computer picture input from the RGB IN connector
Each time you press RGB, the display changes as follows:
RGB 1 ÷RGB 2
RGB
To watch a video picture input from the VIDEO IN jacks
Each time your press VIDEO, the display changes as follows:
VIDEO 1 nVIDEO 2 nVIDEO 3
To turn off the monitor
Press POWER on the remote control. The monitor enters standby mode and the STANDBY indicator lights up. To turn off the main power, press the power switch (green) on the monitor.
Note
To protect the lamp mounted as a source of light, if you try to turn on the power within about 30 minutes after the power has been turned off, the u (power) indicator flashes and the picture does not appear.
Muting the sound
Press MUTING.
“MUTING” appears on the screen.
To restore the sound, press MUTING again, or press VOL+.
Displaying on-screen information
Press DISPLAY to display the following information on the screen.
Watching the picture in wide picture mode
MUTING DISPLAY | POWER |
VIDEO RGB | WIDE |
CENTER/ | MENU |
SIZE |
|
Watching the video picture in wide | |
mode |
|
– 9 –
VIDEO RGB WIDE
CENTER/ | MENU |
SIZE |
|
ENTER
VOL
N
VIDEO
You can also select the input by pressing INPUT SELECT on the monitor.
Each time you press INPUT SELECT, the display changes as follows:
RGB 1 nRGB 2 nVIDEO 1 nVIDEO 2 nVIDEO 3 N
Current input signal
Picture mode (page 14)
RGB 1
Current input
fh:37.5 signal frequency
NORMAL fv:75
when the RGB signal* is input
*fH: Horizontal frequency fV: Vertical frequency
“OUT OF SCAN RANGE” appears if the scanning frequency range is not within the acceptable limits. (See page 9.)
You can enjoy a variety of wide mode picture. | EN |
| |
Press WIDE until the mode you want appears |
|
on the screen. |
|
Each time you press WIDE, the mode changes as |
|
follows: |
|
NORMAL nFULL nZOOM nSUB TITLE nWIDE ZOOM |
|
N |
|
1 If the STANDBY indicator on the front of the monitor is lit in orange, press POWER on the remote control to turn on the power.
POWER
Press the power switch (green) on the monitor if the STANDBY indicator is not lit.
The green u (power) indicator flashes, then lights up.
INPUT SELECT
The input signal indication will automatically disappear.
4 Press VOL +/– (VOLUME +/–) to adjust the volume.
Remote control | Monitor |
VOL | VOLUME |
| + |
| – |
To make the
WIDE
(continued)
Operations |