Radio Shack 15-1634 owner manual 100%6+06*#0600#6117468

and seal the connection with coax sealant tape or a weather boot.

4.Mount the antenna on the mast, and secure it by tightening the hex nuts evenly onto the U-bolts.

.+)*60+0)"2416'%6+10

•Ground wires for both the mast and downlead should be copper or aluminum wire, 8 AWG or larger.

Grounding Clamp

Mast Ground

Wire

•Mount a grounding block (not supplied, available at RadioShack) as close as possible to where the downlead enters the house.

•Downlead wire from the antenna to the grounding block and the mast ground wire should be secured to the house with stand-off insulators, spaced 4–6 feet apart.

Downlead

To TV

Grounding Blocks	Grounding Rod	Lightning
		Arrestor

%100'%6+0)"6*'"#06'00#"61";174"68

300-Ohm UHF	75-Ohm VHF Connection or VHF/
Connection		75- to 300-Ohm Transformer
	UHF Screw Terminals
		Coax Downlead

Signal Splitter

1.Connect the coax downlead from the antenna to the ANT jack on the power injector.

2.If your TV has an F-connector, connect the short piece of coax from the power injector to your TV’s VHF/UHF 75-ohmF-connector.

If your TV has screw terminals for VHF/ UHF connection, connect a 75-to-300 ohm transformer (not supplied, available at RadioShack) between the power injector and the VHF/UHF terminals.

If your TV has a 75-ohm VHF connection and a 300-ohm UHF connection, connect a signal splitter (not supplied, available at RadioShack) between the

Coax Cable Power Injector

power injector and the TV’s VHF/UHF connections.

3.Insert the supplied AC adapter’s small plug into the power injector’s DC 12V jack. Plug the adapter into a standard AC outlet. The power injector’s indicator lights to indicate that the antenna is properly connected.

3