Radio Shack 15-1634 owner manual 1706+06*#0600#, 24/+056#..#6+10656, +05+&/1706+0, 1765+&/1706+0

±"016'"±"

If installing a new lead-in cable, use the actual cable to be used in the installation.

±"016'"±"

If installing the antenna in a motor home, we recommend you use a 12V DC cord (not supplied, available at your local RadioShack store and online at RadioShack.com).

•the amplified TV signal from the antenna, through the power injector, to the video equipment

If any devices (such as amplifiers, splitters, combiners, matching transformers, 300-ohm cable) are used in your home cabling system, they must be connected between the power injector and your video equipment. Any devices connected between the power injector and the antenna might cause a short in the amplifier power source. If this happens, the injector’s indicator does not light and the signals to your video equipment (multiple TVs or VCRs) might be significantly degraded.

24'/+056#..#6+10"6'56

Before installing your antenna, perform this test to make sure it works properly.

1.Connect a temporary 75-ohm cable between the power injector’s ANT 75-

ohm jack and the antenna’s F- connector.±

2.Connect the power injector’s TV cable to your TV’s VHF/UHF 75-ohm F- connector.

3.Insert the supplied AC adapter’s small

plug into the DC 12V jack on the power injector.±

4.Plug the supplied AC adapter into a standard AC outlet. If the power injector’s indicator lights, the antenna is properly connected.

/1706+0)"6*'"#06'00#

+05+&'"/1706+0)

You can mount the antenna in an attic, closet or other out-of-the way indoor location. The antenna can be mounted on a horizontal mast, closet rod, or on a short piece of mast suspended from a roof support by a 4-inch wall-mount bracket (not supplied, available at RadioShack).

Or, you can simply place the antenna on a shelf in a closet. Be sure the antenna is not in a position where it could easily fall or be damaged.

1765+&'"/1706+0)

For the best results, mount the antenna away from trees or other obstructions. Higher frequencies are noticeably affected by these obstructions.

The antenna is easy to install on any antenna mast or optional light-duty mount using simple hand tools and the following additional items (not supplied, available at RadioShack).

•coax downlead (we recommend RG-6 cable for best performance)

•connection sealant tape or weather boots

The antenna package includes these parts:

&GUETKRVKQP	3WCPVKV[
Antenna	1
Antenna Mounting Bracket	1
Mast Clamps	2
1/4-Inch U-Bolts	2
1/4-Inch Split Lockwashers	4
1/4-20 Hex Nuts	4
#12 1/2-Inch Long Self-Tapping	4
Screws
#12 Split Lockwashers	4
Power Injector	1
AC Adapter	1

1.Attach the antenna mounting bracket to the bottom of the antenna using the four #12 (1/2-inch long) self-tapping screws and four #12 split lockwashers.

2.Attach both mast clamps, U-bolts, four

1/4-inch split lockwashers, and four 1/4-20 hex nuts to the mounting bracket. Do not tighten the hex nuts.

3.Plug one end of the 75-ohm coaxial downlead cable to the antenna’s jack

2