Basic Connection
External equipment and cables shown are not supplied with this TV.
Please ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
Basic Connection
Rear of the TV
Mains lead
AC 220 - 240 V, 50 / 60 Hz
AC 110 V - 240 V, 50 / 60 Hz
■Clamper
Aerial
| Satellite dish |
|
| Set top box |
|
| Fully wired HDMI | |
| compliant cable | |
Less |
|
|
than | RF adaptor |
|
10 cm | (supplied) | RF cable |
|
|
Ferrite core - Middle size
(supplied:
Installing the Ferrite core
| Open |
Pull back the tabs | Press the cable |
(in two places) | through and close |
Caution
•Please use the supplied RF adaptor with the supplied middle size ferrite core to comply with the EMC standard.
Attach the clamper
hole
Insert the clamper in a hole
Bundle the cables
Set the
tip in the
hooks hooks
To remove from the TV: To loosen:
snaps |
|
| |
Keep |
| Keep | |
pushing |
| ||
knob | pushing the | ||
both side | |||
| knob | ||
snaps |
| ||
|
|
Note
•Keep RF (antenna) cable away from the mains lead to avoid and minimise mains interference pickup.
•Do not place the RF cable under the TV.
•To obtain optimum quality picture and sound, an aerial, the correct cable (75 Ω coaxial), and the correct terminating plug are required.
•If a communal aerial system is used, you may require the correct connection cable and plug between the wall aerial socket and the TV.
•Your local Television Service Centre or dealer may be able to assist you in obtaining the correct aerial system for your particular area and the accessories required.
•Any matters regarding aerial installation, upgrading of existing systems or accessories required, and the costs incurred, are the responsibility of you, the Customer.
•To obtain optimum quality picture, select either an Aerial or a cable TV network.
•VIERA Link connection (p. 68)
•Other equipment connection (p. 73 - 75)
•Read the manual of the equipment, too.
10