Cisco Systems AIRANT2544V4MR specifications Outdoor Installations, Mounting on a Ceiling

Page 11

Installing the Antenna

Figure 5

Azimuth and Elevation Adjustment

Outdoor Installations

You can mount this antenna outdoors. If you mount the antenna outdoors, you must ensure that the antenna cables exit from the bottom to prevent any water intrusion and to provide a drain for any moisture that may accumulate inside the antenna.

Mounting on a Ceiling

To mount the antenna on a ceiling, follow these steps:

Step 1 Drill a hole in the ceiling approximately 1.25 in. in diameter.

Step 2 Fit the rubber gasket onto the bottom of the antenna.

Step 3 Insert the antenna shaft through the hole in the ceiling.

Step 4 Thread the jam nut onto the antenna shaft and tighten.

Figure 6 shows the ceiling mount process.

Cisco Aironet Dual-Band MIMO Wall-Mounted Omnidirectional Antenna (AIR-ANT2544V4M-R)

 

78-20770-01

11

 

 

 

Image 11
Contents Cisco Systems, Inc. All rights reserved Vswr Technical SpecificationsGHz Antenna 1 Azimuth and Elevation Plane Patterns System Requirements Safety Precautions Choosing a Mounting Location Installation NotesTools and Equipment Required Installing the AntennaAntenna Bracket Mounting on a Vertical SurfaceAntenna Bracket Attached to Mounting Bracket Wall Mounting Mounting on a Ceiling Outdoor InstallationsMounting on a Mast Suggested Cable Obtaining Documentation and Submitting a Service Request