To use Composite terminals

(for SD picture)

(Camcorder / Game system / DVD recorder / etc.)

VIDEO cable

AV Equipment (e.g. Camcorder)

Note

●In some cases, it is not possible to connect depending on the type of cable or equipment.

●The Green terminal is shared for both the COMPONENT and COMPOSITE (VIDEO IN) connection. When using COMPOSITE (VIDEO IN) connection, the Yellow connector (VIDEO) should be inserted into Green connection.

Network connection

●To enable the network service functions, you need to connect the TV to a broadband network environment. If you do not have any broadband network services, please consult your retailer for assistance.

●Prepare the Internet environment for wired connection or wireless connection.

■Wired connection

Internet environment

LAN cable (Shielded)

■Wireless connection

Internet

environment

Built-in wireless LAN

Access point

■About built-in wireless LAN/Bluetooth

●To use the built-in wireless LAN, using an access point is recommended.

●To use the built-in wireless LAN in the access point mode, up to 7 devices are connectable. But the transfer rate will vary according to communication environment or connected equipments.

●Do not use the built-in wireless LAN to connect to any wireless network (SSID*1) for which you do not have usage rights. Such networks may be listed as a result of searches. However, using them may be regarded as illegal access.

●Check that the Access point supports WPS*2.

(If it does not support WPS, the encryption key of the Access point is required when configuring settings.)

●Follow the instructions on the Access point setup screen and configure the appropriate security settings.

For more details on setting of Access point, please refer to operating manual for the Access point.

●We recommend using 11n (5 GHz) for the wireless system between the built-in wireless LAN and Access point.

Communication is also possible with 11a, 11b, and 11g, but the communication speed may be slower.

●If the wireless system of the Access point is changed, devices that could connect by wireless LAN may no longer be able to connect.

●Data transmitted and received over radio waves may be intercepted and monitored.

●Keep the TV away from the following devices as much as possible:

Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the TV failures such as malfunction may occur due to the radio wave interference.

●When noises occur due to the static electricity, etc., the TV might stop operating for the protection of the devices. In this case, turn the TV Off with power On / Off switch, then turn it On again.

*1 SSID is a name for identifying a particular wireless network for transmission.

*2 WPS: Wi-Fi Protected Setup

English 15