Marantz UD7006 Inserting the batteries, Remote control settings remote control side, GExampleH

Inserting the batteries

Operating range of the remote control

ENGLISH

Remote control

Remote control settings (remote control side)

Simple

qSlide the rear lid in the direction of the arrow and remove it.

wLoad the two batteries properly as indicated by the marks in the battery compartment.

R03/AAA

Point the remote control at the remote sensor when operating it.

Approx. 23 ft /7 m

30°

30°

Switches when this unit remote control operates another Marantz BD players in the vicinity.

Set the remote control code simultaneously on the unit, too (vpage 39 “Remote ID”).

GRemote control code settingH

•The supplied remote control has two remote control code settings: BD 1 and BD 2.

•The code is set to “BD 1” at the factory.

•To set the code to “BD 2”, hold the 2 and the Number button (2) pressed for more than five seconds.

•To set (return) the code to “BD 1”, hold the 2 and the Number button (1) pressed for more than five seconds.

version

Basic version

ePut the rear cover back on.

NOTE

•Insert the specified batteries in the remote control.

•Replace the batteries with new ones if the set does not operate even when the remote control is operated close to the unit. (The supplied batteries are only for verifying operation.)

•When inserting the batteries, be sure to do so in the proper direction, following the q and w marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not attempt to charge dry batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•Do not keep the battery in a place exposed to direct sunlight or in places with extremely high temperatures, such as near a heater.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•Remove the batteries from the remote control if it will not be in use for long periods.

•Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.

NOTE

The set may function improperly or the remote control may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.

If the signal code of the remote control does not match the signal code of the unit, the remote control code set on the unit is shown on the display.

GExampleH

If the code setting on the unit is “BD1”, and the setting on the remote control is “BD2”, “BD1” is shown on the display.

NOTE

Match the signal code of the remote control with the signal code of the unit. If the remote control code is different, you cannot operate the this unit with the remote control.

Advanced version

Information

47