Model D4327/D4328
Quick Release Wood Vise
Instruction Sheet
Phone #: (360)
Introduction
Your new Model D4327/D4328 Quick Release Wood Vise (Figure 1) is designed to fit on workbenches 21⁄4" and thicker, but can be adapted to workbenches down to 11⁄2" thick by using a shim. Holes are
D4327 Specifications
• | Jaw Width | 7" |
• Mounting Height (Workbench Thickness) | 21⁄4" | |
• | Maximum Jaw Opening | 8" |
• | Weight | 21 lbs. |
D4328 Specifications
• | Jaw Width | 9" |
• Mounting Height (Workbench Thickness) | 21⁄4" | |
• | Maximum Jaw Opening | 10" |
• | Weight | 25 lbs. |
Installation
1.Have another person hold the vise up against the workbench in the desired mounting location. If the workbench has holes for bench dogs, make sure the bench dog on the vise is aligned with those holes.
Note: If the workbench is less than 21⁄4" thick, use a piece of scrap wood (Figure 2) between the vise and workbench as a shim. Cut the shim to the necessary thickness so the vise does not protrude above the workbench after mounting.
2.Pencil mark the workbench through the mounting holes to establish locations to drill pilot holes.
3.Use a 1⁄8" drill bit to drill pilot holes approximately 11⁄2" deep in the face of the workbench, where the wood screws will be used (see Figure 3).
Figure 1. Quick release wood vise.
Workbench |
Shim |
Vise |
Figure 2. Shim placed between workbench
and vise for workbenches under 21⁄4".
Mounting Holes |
for Wood |
Screws |
Mounting |
Holes for Lag |
Screws |
Figure 3. Mounting hole locations.
COPYRIGHT © MARCH, 2012 BY WOODSTOCK INTERNATIONAL, INC.
| WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT | |
#14922ST | THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. | Printed in China |
| ||