Function setup
Customizing the Function Settings
Speaker Setting
Once the speakers are connected to the system and properly configured, you can check to verify that the connections to the speakers are correct by running an audio speaker test.
To run this test, follow the instructions described as below:
1.In the main menu of Settings, press 
button, then use
/ 
button to select Speaker, then press OK.
Note: This setup menu item has no effect unless:
•If you have selected ‘Bitstream Mixed’ in the audio menu, these menu choices will have no effect. (Each channel’s full audio spectrum will be sent to each speaker, regardless of the speaker size selected)
•If you don’t know the type of speakers attached to your surround sound system, consult the manual for your speaker system.
2.Use 
/ 
/ 
/ 
to highlight the desired speaker, then press OK to enter.
3.Press 
/ 
to choose the desired audio signal, and then press OK to confirm.
Front Left & Right Speakers:
•By setting the front left speaker’s size, the front right speaker’s size is automatically changed to match.
•The front speakers can not be turned off. They can only be set to ‘Small’ or ‘Large’.
Center Speaker:
•If the front speakers have been set to small, the center speaker can only be set to ‘small’ or ‘Off’.
•Setting a speaker to ‘off’ will result in no sound being delivered to that speaker.
Subwoofer:
•If you don’t know the crossover frequency of your subwoofer, consult the manual for your speaker system.
Surround Left & Right Speakers:
•By setting the left surround speaker’s size, the right surround speaker’s size is automatically changed to match.
•If the front speakers have been set to small, the surround speakers can only be set to ‘Small’ or ‘Off’.
Rear Left & Right Speakers:
•By setting the left rear speaker’s size, the right rear speaker’s size is automatically changed to match.
•If the front speakers have been set to small, the rear speakers can only be set to ‘Small’ or ‘Off’.
4.Use 
/ 
/ 
/ 
to move the highlight box to the Test button on the bottom, then press OK. A message will appear.
5.Press 
/ 
to choose the desired audio signal. You can select between Pink, 1kHz Sine and White.
6.Press OK to begin the speaker test. The audio signal will be sent to a different speaker every approximately every two seconds. The audio test will highlight which speaker is supposed to be getting the sound on the screen.
7.To stop the audio test, press one of the 
/ 
/ 
/ 
buttons.
8.Press 
or RETURN to go to the previous menu.
32