11. SETUPS
11.1. Network Connection
HOME A “Settings” A “Network” A “Network Connection”
Perform the network connection setup in order to use the network features, such as
Connection Test
After you enable a network connection or change the network settings, always perform the connection test to check to see if the connection is correctly made.
1.Use [
] to select “Settings” in the Home Menu, then press [OK].
2.Use [
] to select “Network”, then press [OK].
3.Use [
] to select “Network Connection”, then press [OK].
4.Use [
] to select “Connection Test”, then press [OK].
• Connection test will automatically start. The test result will appear right after the test finishes. - “Connecting...”: The test is in progress.
- “Pass”: Connection test is successfully completed.
- “Failed”: Connection test failed. Check the connection settings.
5.If the connection test passes, press [OK].
DNote
•If the connection test passes, you are ready to use
•If the connection test fails, you may need to check your router settings and make sure the physical connection is secure. If you need the MAC address of this unit to complete your router settings, you can view it on the “Network Status” / “Wireless Status” screen (refer to page 42).
•When connecting this unit directly to a modem for the first time or connecting it to a modem which was previously connected to any other network device (e.g. a router, PC, etc.), you may have to power cycle the modem (unplug the modem’s and/or router’s AC plug from its AC outlet for 30 seconds and then plug it back in), this may reset the settings in the modem. If you have a telephone/Internet modem with your cable service then you may have to use its reset button or remove the backup battery to reset this type of modem.
•If “Home Network” failed on the connection test, this unit is not connected to the router / local network. In this case, you cannot use your DLNA home media server(s).
•If “Internet” failed on the connection test, this unit is not connected to the Internet. In this case, you cannot use the
Wired Connection
Select “Wired” if you made a wired connection and set the setting to “Auto” or “Manual”, in accordance with your network environment.
Auto (Wired)
Select “Auto” to set the network setting automatically.
1.Use [
] to select “Network Setup” in the Home Menu, then press [OK].
2.Use [
] to select “Wired”, then press [OK].
3.Use [
] to select “Auto”, then press [OK].
• The unit will automatically start the connection test. The test result will appear right after the test finishes.
4.“Network connection succeeds.” will be displayed. Select “End” then press [OK] to complete the settings.
continued on next page
EN - 38