Receiver Operations
Presetting Radio Stations
You’ll most likely want to preset the receiver with the radio stations you listen to often so that you don’t have to tune in the station every time. The receiver can store a total of 30 FM or AM stations. You can store the stations on preset numbers combining 3 characters (A, B, C) and numbers (0 - 9). For example, you can store a station as preset number A1, B6 or C9, etc.
Numeric buttons | SHIFT |
TUNER MEMORY
1Press TUNER.
The last received station is tuned in.
2Tune in the station you want.
If you are not familiar with how to tune in a station, see “Receiving Broadcasts” on the previous page.
3Press MEMORY.
“MEMORY” appears for a few seconds.
Do steps 4 and 5 before “MEMORY” goes out.
4Press SHIFT to select a character (A, B or C). Each time you press SHIFT, the letter “A,” “B” or “C” appears in the display.
If “MEMORY” disappears, start again from step 3.
5While MEMORY is displayed, press the number you want to use (0 to 9).
6Repeat Steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to change.
Note
If the AC power cord is disconnected for about one week, the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.
Tuning preset stations (preset tuning)
You can tune directly to a preset station by entering its preset number. If you don’t know which stations are preset on which numbers, you can tune by scanning the preset stations.
1Press TUNER.
The last received station is tuned in.
2Press SHIFT to select a character (A, B or C), then press the number.
For example, select A and then press 7 to tune in the station preset as A7.
You can tune by scanning the preset stations
First press TUNER and then press PRESET TUNING + or – to select the station you want. Each time you press the buttons, the preset numbers change as follows:
n A 1 ˜ A 2 ˜ … ˜ A 0 ˜ B 1 ˜ B 2 ˜ … ˜ B 0 N
n C 0 ˜ … ˜ C 2 ˜ C 1 N
10