RCA D770 manual Key Description

Page 3

Key Description

ANTENNA In TV Mode, lets you switch the source of the video signal from satellite signals to an off-air antenna

or cable signal when using the OUT TO TV jack. In VCR Mode, it functions as a TV/VCR input key.

ARROWS Use the navigation arrows to move the on-screen highlight up, down, left, or right. Using the arrows to highlight a menu item is also called “pointing.”

CH + (UP)/ - (DOWN) Use to scan up and down through the channels in the current channel list. If you are in the program guide or menu system, use the CH +/- keys to page up and down a screen at a time. You can also use the CH +/- keys on the top of the digital satellite receiver to change the channel.

CLEAR Removes the on-screen displays and returns you to normal viewing.

COMPONENT KEYS When programmed, these keys are used to put the remote in a specific mode so that it can control that component.

AUX1 and AUX2 Act as “wildcard” keys. They can be programmed to control another TV, VCR, DVD, satellite receiver, cable box, or an audio component. Follow the direct entry programming instructions on page 7 to program these keys.

Note: The AUX1 key is pre-programmed with codes to control a Dish Network digital satellite receiver.

DVD Puts the remote in DVD Mode.

SAT Puts the remote in SAT Mode. This key is pre-programmed

to control an RCA DIRECTV® digital satellite receiver manufactured before 2004.

Note: This key cannot be reprogrammed. If the SAT key doesn’t control your receiver, use the AUX1 key to program the remote to control your satellite receiver if it was purchased after 2003.

TV Puts the remote in TV Mode.

VCR Puts the remote in VCR Mode.

Digit Keys (0-9) Use the digit keys to tune directly to a three-digit satellite channel or non-satellite channel. If a satellite channel number is less than four-digits long, you must press OK after entering the channel number. If you are in the menu system, use the digits to highlight and select items. Use 0 to return to the previous menu screen.

FETCH Either brings up the Fetch menu or tells the receiver to take the action you programmed it to take.

GO BACK Moves you back and forth between the last two selected channels. In the menu system, returns you to the previous screen.

GUIDE Brings up the program guide. Subsequent presses of the GUIDE key switch between the Detail and Grid guide formats.

INFO Brings up the on-screen channel banner, password challenge, or purchase offer screen. Press again to get program details. In the program guides, press INFO to get information about the highlighted program or channel.

4

Image 3
Contents Remote Battery Installation Table of ContentsKey Description Programming The Remote Control Programming For TV-Direct Entry Method Programming For VCR-Direct Entry MethodProgramming For DVD-Direct Entry Method CH+ Channel UP or the Onoff key. If the component responds Programming The AUX1 And AUX2 KeysUsing Automatic Code Search Using The Remote To Control a ComponentChanging The RF Remote Control Code Menu Function Entering the Menu ModeTroubleshooting Problem The VCR won’t record Questions Limited Lifetime WarrantyProscan products without any programming Consolidate Five Remote Controls Into One