Adder Technology X2 manual Configuration, What are hotkeys?, To enter and use configuration mode

Special configuration

Configuration

You can alter the way that the X2 Dual Access modules operate to suit your requirements. This is done using the Configuration mode and you can affect the following settings:

•Password setting – allows you to lock the remote module to prevent unauthorised system access.

•Mouse restoration and settings – allows you to restore mouse operation and also to change the mouse type.

•Image controls - sharpness & brightness – allows you to manually adjust the video image to ensure that it is crisp and bright.

•Skew adjustment – allows you to manually compensate for possible video errors introduced by long, uneven cable connections.

•Miscellaneous functions – report firmware version and restore settings.

What are hotkeys?

Hotkeys are two normal keyboard keys that, when pressed simultaneously with a third key, signal to the X2 Dual Access modules that you are sending a message

specifically to them and not to the computer. The hotkeys are ordinarily and , while a third keypress determines what you want the modules to do.

If the standard and hotkeys are also needed for computer tasks, you can change them for another combination using switches 2 and 3 on the REMOTE module:

2	OFF
3	OFF	Hotkeys =	and	(default setting)
2	OFF
3	ON	Hotkeys =	and
2 ON
3	OFF	Hotkeys =	and
2 ON
3	ON	Hotkeys disabled

Entering, using and exiting configuration mode

To enter and use configuration mode:

1 Simultaneously press the currently configured

hotkeys (by default, and ) along with .

The three keyboard indicators (‘Num Lock’, ‘Caps Lock’ and ‘Scroll Lock’) will now begin to flash in sequence to show that you are in configuration mode.

2	Press the first letter of the required configuration	Scroll
		Lock
	option, for instance .	s
		Capck
		Lo
	All three keyboard indicators will illuminate	m
		Lo
		Nu ck
	continuously.
3	Press the number of the required configuration	Scrollck
	option, for instance .	Lo
		Capck
		s
		Lo
	The ‘Scroll Lock’ indicator will extinguish, leaving	Numck
	the ‘Num Lock’ and ‘Caps Lock’ indicators lit.	Lo

4 Press to confirm your option.

The three keyboard indicators (‘Num Lock’, ‘Caps Lock’ and ‘Scroll Lock’) will now begin to flash in sequence again.

To exit from configuration mode:

1Within configuration mode, the three keyboard indicators should be flashing in sequence to show that the module is ready to receive a new command.

2 Press .

The three indicators will return to their normal states.

        

14