ATP/AST Series Product Specifications
7. Revision history
Rev1 (April 15, 1998)
Initial release
Rev2 (June 1, 1999)
The overall revision by specification review.
Rev3 (April 1, 2002)
The address in the office was changed by the move.
Rev4 (August 16, 2002)
1-4.Activation Force is changed “50g± 30g” to “0.5N±0.3”. 1-4.Light Transmission is changed 76% to 80%(TYP).
Rev5 (September 3, 2002)
1-3.Operating Temperature is changed “0°C to 60°C” to “-20°C to 70°C”. 1-3.Storing Temperature is changed “-20°C to 70°C” to “-40°C to 80°C” 1-4.Operating Life is changed “1,000,000 hits” to “10,000,000 hits”.
1-5.Linearity is changed “Under ±2%” to “Under ±1% (typical value)”.
Rev6 (June 28, 2004)
1-3.Operating Humidity is changed “Less than 90%RH (no condensation)” to “-20°C to 60°C Less than 90%RH (no condensation) Exceeding 60°C 133.8g/m3 (no condensation)”.
1-3.Storing Humidity is changed “Less than 95%RH (no condensation)” to “-40°C to 60°C Less than 95%RH (no condensation), Exceeding 60°C 142.9g/m3 (no condensation)”.
1-5.Maximum Voltage is changed “DC5V” to “DC6V”.
1-5.Linearity is changed “Under ±1% (typical value)” to “Under ±2% (Under ±1% (typical value))”.
Rev7 (October 15, 2004)
4-4.Electrical & Software Notice: Changed “FIT-10 series” to “TSC-10 series”.
Rev8 (April 7, 2005)
Added Item4 Recommended Connector.
Rev9 (September 6, 2005)
2-3.Mechanical Characteristics: Added Operating Life Test (Pen).
11 | Rev. 10©1999 - 2006 DMC Co., Ltd. |
