3M 325 owner manual Installation, Specifications

Page 11

Installation

Specifications

Environmental

Do not place the Mediacheck in an enclosed area or any place where excess heat can build up.

Relative Humidity (operation)

5% to 95% RH, non-condensing

 

 

Relative Humidity (storage)

5% to 99% RH, non-condensing

 

 

Operating Temperature

32°F to 104°F (0°C to 40°C)

 

 

Storage Temperature

-40°F to 131°F (-40°C to 55°C)

 

 

Dispose of this product according to federal, state, and local disposal regulations to avoid hazards and harm to the environment.

Power Requirements

100 to 120 Vac, 0.8 A, 50/60 Hz, single phase, 100 watts or

200 to 240 Vac, 0.4 A, 50/60 Hz, single phase, 100 watts

The user must set the voltage selection switch (located on the Mediacheck rear panel) to the voltage supplied by the library.

Dimensions

 

Depth:

13.2 in. (33.5 cm)

Height:

9.4 in. (23.9 cm)

Width:

9.7 in. (24.6 cm)

Power cord length:

9 feet (2.74 meters)

Weight

Approximately 16.0 lbs. (7.26 kg)

9

Image 11
Contents 3M Library Systems Mediacheck ModelPage Table of Contents Page Introduction Safety InformationSafety Messages Safety Message FormatFollowing safety messages appear in this manual Safety Messages Contained in this ManualFollowing labels are applied to the equipment Safety LabelsExplanation of Labels and Symbols Safety Label ReplacementLabel Locations Safety Label LocationsJapan EMC, USA, and Canada ComplianceEMC Compliance Europe Page Specifications InstallationStaff preferences and ergonomic considerations Site PlanningWorkflow considerations Space considerationsMediacheck Orientation Equipment orientationPower selection switch settings Equipment SetupMedia Processing Guidelines OperationOverview Media OptionsControls and Indicators Controls and IndicatorsProcessing Items When the Mediacheck is part of a SelfCheck System V-SeriesStandalone Mode Volume Adjustment CleaningTroubleshooting United States Canada Service Information3M Service Phone Numbers System Information