CTGAE3P 3021 manual booklet 5/24/04 12:46 PM Page 10
5. | Repeat step 4 (on the previous page) three more times for |
| remaining digits. Use 2 for the second digit, 3 for the third |
| digit, and 4 for the fourth digit. Write down the code dig- |
| its in the remaining TV code boxes on page 8. |
6.To check for codes of other devices, repeat steps 1 through 5 (starting on the previous page), but substitute the appropriate device key for each device you are check- ing. Write down the device’s code digits in the appropriate code boxes on page 8.
PROGRAMMING A MASTER POWER MACRO
In its default state, the POWER key on the One For All 3 Device Universal Remote Control will individually power your home entertainment devices on or off. However, you can also program a Master Power Macro onto the POWER key that will sequentially turn on or off all the devices with a single key press.
Programming The Power Key For The Master Power Macro
1.Press and hold SET until the LED (red light) blinks twice, then release SET.
2.Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.
3.For the first device you want in the
4.Repeat step 3 up to two more times to add desired devices to the
5.To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET.
Operating The Master Power Macro
1.After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequen- tially turn on (or off) your devices.
NOTE: When POWER is pressed for less than 2 seconds, a power com- mand will only be sent to the
2.Devices will turn on (or off) according to your pro- grammed sequence.
NOTE: The
NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s). This action is normal.
continued on next page...
10