Pentair X-10 Section II. Operating Instructions, To change the House code, To change the battery

Section II. Operating Instructions

1.Plug in the Transceiver (see Figure 2) and extend antenna.

NOTE

The Transceiver is NOT weather-proof and MUST be installed indoors at least 5 feet from the pool or the minimum distance from the pool that local building codes require.

2.Using the keychain remote (see Figure 2), press the first (top) ON button to turn on power for the PG2000 bulb, press the first (top) OFF button to turn off. Press the second ON button to start the colorwheel, press the second OFF button to stop the colorwheel.

On1		Off	X-10 POWERHOUSE
			HOUSE
			O	.	A .	C
	2
On		Off	.			.
			M.			.E
			K .		. G
					I

ON/OFF

	Transceiver
Keychain Remote	Module

Figure 2.

NOTE

Power to the PG2000 must be pressed first before being able to start the colorwheel.

A.To change the HOUSE code:

•Take the keychain remote, press and hold the first (top) ON button. While holding down, the red LED will blink once, 3 seconds later, the LED will then blink the current setting: 1 blink for HOUSE code A, 2 blinks for B, …, 16 for HOUSE code P.

•Release the ON Button.

•Press and release the first (top) ON button the number of times for the HOUSE code you want to set: 1 for A, 2 for B, … 16 for P. The LED will blink for each press.

•VERIFY the new setting by holding down the first (top) ON button, the LED will turn on, 3 seconds later, the LED will then blink the new setting.

B.To change the UNIT code for the first (top) two buttons: (the second pair of ON/OFF buttons are always one number higher than the first pair, i.e. if you set the first button to 6, the second button controls 7).

•Press and hold the top OFF button. The red LED will blink once, 3 seconds later, the LED will then blink the current setting: 1 blink for UNIT code 1, 2 blinks for 2, …, 16 blinks for 16.

•Release the top OFF button.

•Press and release the top OFF button the number of times for the UNIT code you want.

•VERIFY the new setting by holding down the top OFF button, the LED will turn on, 3 seconds later, the LED will then blink the new setting.

C.To change the battery:

•Pry the keychain remote apart and fit a CR2025 Lithium 3V battery into slot. Observe the polarity.

NOTE

If the unit is cycled off then on it may take up to 3-4 minutes for the lamp to “restrike” or come back on. All metal halide lamps have this characteristic and this is a normal function of the PG2000.

Rev. A 12-5-03 3

TOGGLE SWITCH POSITIONS
	MANUAL CONTROL
POWER	COLOR	POWER	COLOR
OFF	OFF	ON	ON
REMOTE SWITCH CONTROL		RF2000 WIRELESS CONTROL
POWER	COLOR	POWER	COLOR
Figure 3.
			P/N 840344