Pentair QT4 Section VI. Customizing the Communication Link, Hand-held Remote

Page 5

SECTION VI. CUSTOMIZING THE COMMUNICATION LINK

The communication link between the Receiver and Hand-held Remote can be customized to prevent electrical interference. To accomplish this, there is a 10-position configuration switch located on the Receiver circuit board, and inside the Hand-held Remote. Units are shipped from the factory with all switches in the ON position.

If you wish to change this setting, use a paper clip or other blunt instrument and adjust both 10-position configuration switches to matching settings. If the configuration switch setting at the Receiver does not match that of the Hand-held Remote the communication link will not function.

COM LINK

Light

COMMAND

Light

Receiver

Switch

Hand-held Remote

Battery

Compartment

NOTE: All Program Switches are Factory set to “ON”.

If the IntelliTouch system has not been set to a new house address you should do so now. To set a new House Address consult the main system instructions. The Load Center System Control lights will blink repeatedly when a house address is being sent out.

If the system is sending a new house address, the COM LINK and COMMAND lights will blink together repeatedly on the QT4 board.

If the system is sending an existing house address, the COM LINK and COMMAND lights will blink alternately.

While this is happening press any button of the Hand-held Remote. The COM LINK and COMMAND lights will blink alternately. The main system may now be RESET. Wait for Auto Mode and the QT4 lights to stop blinking before resuming normal operation.

SECTION VII. HAND-HELD REMOTE BATTERY REPLACEMENT

With normal use the battery should last for several years. In the event the battery must be replaced, slide the cover from the bottom of the Hand-held Remote. Slide the battery from the retainer clip and discard in accordance with local and/or state ordinances. Replace with 3V lithium battery number CR2032 or equivalent. Slide battery cover onto remote and snap in place.

Rev. A 7-25-03

5

P/N 520209

Image 5
Contents Function Hand-Held Wireless Remote Control Section I. Application Using the HAND-HELD RemoteSection KIT Includes Section III. HAND-HELD RemoteGetting There Section IV. Configuring ButtonsLoad Center Section V. InstallationReceiver Hand-held Remote Section VII. HAND-HELD Remote Battery ReplacementSection VI. Customizing the Communication Link Symptom Possible Cause Solution TROUBLE-SHOOTINGPentair Pool Products ~ Pentair Pool Products