Trouble-Shooting, Symptom Possible Cause Solution

TROUBLE-SHOOTING

Symptom	Possible Cause	Solution

POWER LED does not light.	Load Center does not	Insure power is being supplied
	have power.	and that the Load Center
		operates correctly without the
		receiver installed.
	Defective cable or connection	Verify the function of the board
	to the Load Center.	using known good cable set.
	Defective receiver board.	Contact factory or service center.

COM LINK LED does not light or blink.	Defective cable or connection to the	Verify the function of the board using
	Load Center.	known good cable set.
In normal operation LED will blink at	Defective receiver board.	Contact factory or service center.
least every 2 seconds.

COMMAND LED does not light when	Address switches are incorrectly	Verify that the address switches on
Hand-held Remote button(s) is pressed	configured.	the Hand-held Remote and receiver
- unit fails to operate.		board are correct and match.
	Hand-held Remote battery has failed.	Replace Hand-held Remote battery.
	Defective Hand-held Remote or receiver.	Contact factory or service center.

Unit functions, but some circuits do	Circuit selections incorrectly	Verify settings at Control Panel:
not work, or operate the incorrect	configured.	MENU/SETUP/ADV/REM/QT REMOTE
circuit.

Unit fails to operate, or fails to operate	Undue electrical noise.	Relocate the receiver away from
dependably at range.		equipment such as blower motors.
	Too many obstructions between the	Relocate the receiver in a location
	Hand-held Remote and receiver.	that provides fewer obstructions to
		the area the user commonly
		operates the Hand-held Remote.
	Receiver unit is too near the ground.	Relocate the receiver to maximize
		the distance between the receiver
		antenna and the ground.

Unit seems to turn on or off circuits	A nearby home is operating a similar	Select an alternate address code for
without the user / Hand-held Remote.	wireless unit.	theHand-heldRemoteandreceiver.
		I.e. change the switches on both boards
		to an alternate, but matching setting.

Unit dependably turns equipment ON,	Undue electrical noise is being	Relocate the receiver away from
but once equipment is running it does	produced by one or more pieces of	equipment such as blower motors.
not dependably turn equipment OFF,	equipment in close proximity to
or range is greatly reduced when	the receiver.
equipment is running.
		Relocate the receiver in a location
		that provides fewer obstructions to
		the area the user commonly operates
		the Hand-held Remote.

Unit operates, but has greatly	Hand-held Remote battery is failing.	Replace Hand-held Remote battery.
reduced range compared to prior
function.

P/N 520209

Rev. A 7-25-03