7.Set the SET temperature to at least 2º F (1º C) below the room temperature and the system flame will extin- guish. Thereafter, it should continue to cycle on and off thermostatically approximately every two minutes as the ROOM temperature changes, but only when the temperature differential between ROOM and SET temperatures differs at least 2º F (1º C). The 2º F dif- ferential is the factory setting.
Timer Operation
The countdown timer will operate in either the manual ON or THERMO mode. Once the fireplace system is in an operating mode, set the countdown timer to turn off in 15 minutes. The timer function will allow operation to continue until the “countdown time” on the LCD screen expires. After 15 min. elapses, the system should turn off.
GENERAL INFORMATION
Transmitter Wall Bracket
The transmitter can be hung on a wall using the bracket provided. Locate the bracket on an inside wall sufficiently far away from direct sources of heat such as a fireplace, incandescent lighting, or sunlight so it detects ambient room temperatures, not a single heat source. If the bracket is installed on a solid wood wall, drill 1/8” pilot holes and install with the screws provided. If it is installed on a plas- ter/wallboard wall, first drill two 1/4” holes into the wall, then use a hammer to tap in the two plastic wall anchors flush with the wall, then install the screws provided.
Battery Life
Life expectancy of the batteries in the transmitter should be at least 12 months. Check batteries annually. When the transmitter no longer operates the remote receiver from a distance it did previously (i.e., the transmitter’s range has decreased) the batteries should be checked.
Specifications |
| ||
| Power Requirements: | 3V 2 ea.; AAA 1.5V, Alkaline | |
Transmitter | Operating Frequency: | 303.8 MHZ | |
FCC ID No.’s: | K9L300ITX | ||
| Canadian ISC ID No.’s: | 2439 102 760 | |
| Power Requirements: | ||
Remote | Operating Frequency: | 303.8 MHZ | |
FCC ID No.’s: | K9L3003RX | ||
| |||
| Canadian ISC ID No.’s: | 2439 102 760A | |
Service Parts List
DESCRIPTION | SERVICE PART NO. |
HTI | |
|
|
|
|
TRANSMITTER WALL HOLDER | HTI |
|
|
HTI | |
|
|
RECEIVER | HTI |
|
|
TRANSMITTER | HTI |
|
|
TRANSMITTER | HTI |
|
|
TRANSMITTER | |
|
|
HARDWARE PACKAGE | HTI |
|
|
Limited Warranty
This REMOTE CONTROL SYSTEM is warranted for 12 months from the date of purchase or installation to the original purchaser to be free from defects in materials and workman- ship. Damage to the SYSTEM caused by accident, misuse, abuse, or installation error whether performed by a contractor, service company, or owner, is not covered by this warranty. Seller will not be responsible for labor charges and/or damage incurred in installation, repair, replacement or for incidental or
consequential damages. Batteries and any damage caused by them are not covered by this warranty.
Some states, provinces, and nations do not allow exclusion or limitations of incidental or consequential damages, so the above limitations or exclusions may not apply. This warranty gives you specific legal rights. You may have other rights that vary by state, province or nation.
Hearth & Home Technologies • | 9 |