RC200
IntelliFire Plus™ Multifunction Remote Control
Installation & Operating Instructions
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged system component.
•Modification of the system component.
•Installation other than as instructed by Hearth & Home Technologies.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
•Read, understand and follow these instructions for safe installation and operation.
Introduction
The RC200 multifunctional wireless control with dock- ing station is designed to control constant pilot feature, flame height, blower speed and to turn your gas fire- place on and off. The RC200 remote control is only for use with the Hearth & Home Technologies IntelliFire Plus™ system (IPI).
FCC Requirements
WARNING! Risk of Fire! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in ac- cordance with the instructions, may cause harmful in- terference to radio communications. However, there is no guarantee that interference will not occur in a partic- ular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected.
•Contact the dealer or an experienced radio TV techni- cian for help.
Canadian Equipment Requirements
This digital apparatus does not exceed the (Class A/ Class
B)limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Cana- dian Department of Communications. Le present appareil numerique n’emet pas de bruits radioelectriques depas- sant les limites applicables aux appareils numeriques (de la class A/de la class B) prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada.
This device complies with
Installation Precautions
This control is tested and safe when installed in accor- dance with this installation manual. Do not install any components that may be damaged.
Do not modify, disassemble, or substitute any of the com- ponents included with this kit. Installation of this unit must be done by a qualified service technician.
Placement of this remote control may affect performance. An assessment of the space should be done prior to in- stallation for optimum performance.
Determine Location
Determine the location for the remote control. The selected location should be in the same space as the gas fireplace with visual sight of fireplace. The remote control must be placed within 30 feet of the fireplace but should not be exposed to extreme heat.
The RC200 is approved for interior installation and should always be placed under weather resistant cover when used in exterior applications.
• Keep remote control out of reach of children.
Hearth & Home Technologies • RC200 Multifunction Remote Control • | 1 |