Philips FW-D5D manual CD Player Operation, Radio Reception, General

Page 42

TROUBLESHOOTING

English

42

CD Player Operation

"NO DISC" is displayed.

The disc is inserted upside down.

Place disc with printed side up.

Moisture condensation at the lens.

Wait until lens has adjusted to normal room temperature.

There is no disc in the CD tray.

Insert a disc.

The disc is dirty, badly scratched or warped.

Clean or replace the disc.

• The disc lens is dirty or dusty.

See section under Maintenance (page 41).

"DISC NOT FINALIZED" is displayed.

The CD-RW or CD-R disc is not properly recorded for use with a standard CD player.

Read the instruction booklet of your CD-Rewritable or CD-Recorder on how to finalize a recording.

The CD is badly scratched or dirty.

Replace or clean CD.

Radio Reception

Poor radio reception.

The signal is too weak.

Adjust the antenna.

Connect an external antenna for better reception.

The TV or VCR is too close to the stereo system.

Separate the stereo system from the TV or VCR.

General

System does not react when any button is pressed.

• Electrostatic discharge

Press STANDBY ON to switch the system off. Remove the AC power plug from the wall outlet, then reconnect the power plug and switch on the system again.

No or poor sound.

Volume is not turned up.

Adjust VOLUME.

The headphones are connected.

Disconnect the headphones.

Speakers are not connected or are

connected wrongly.

Check that the speakers are connected correctly.

Make sure the stripped speaker wire is clamped.

Reversed left and right sound.

Speakers are connected wrongly.

Check the speaker connections and location.

Lack of bass sound or apparently imprecise physical location of musical instruments.

Speakers are connected wrongly.

Check the speaker connection for proper phasing, colored/black wires to colored/black terminals.

Remote control has no effect on the system.

• Wrong source is selected.

Select the source (CD,TUNER, etc.)

before pressing the function button (É, í, ë, etc.).

The distance to the system is too large.

Reduce the distance.

Batteries are inserted incorrectly.

Insert the batteries with their polarities (+/– signs) as indicated.

Batteries are exhausted.

Replace the batteries.

Timer is not working.

Clock is not set.

Set the clock.

Timer is not switched on.

Press TIMER to switch on the timer.

Clock setting is erased.

There was a power failure.

Reset the clock.

System displays features automatically; buttons flash continuously.

Demonstration mode is switched on.

Press and hold Ç (on the system) for five seconds to switch off the demonstration.

There is a howling sound at the external source.

You hear feedback when you are listening in AUX mode

Press AUX to select CDR mode.

All lighted buttons are not lit.

Display is switch on in DIM 3 mode.

Press DIM until DIM OFF display mode is shown.

pg 01-43/D5/37-Eng

42

7/13/00, 11:52 AM

3139 116 19774

Image 42
Contents FW- D5 3139 116Warranty Verification Congratulations on your purchase, and welcome to the family Dear Philips product ownerEnglish EL 4562-E004 99/3Set complies with the FCC-Rules, Part 15 and with 21 CFR Index Class Laser ProductEspañol Français English Type Region code for this set isFor Customer Use DVD-VIDEO General Information Safety Information Rear Connections FM Wire AntennaPreparation AM Loop AntennaSpeakers Connection Wireless Surround Out ConnectionConnecting other equipment to your System Center Speaker ConnectionAudio Digital Out Connection AC Power SupplyInserting batteries into the Remote Control Insert the batteries Type R06 orControls Disc Change OpencloseCD / CD Controls on the system and remote controlSearchtuning à á CD 1 / CD 2 / CD 3 CDË, etc Switching the system to standby mode Switching the system onDemonstration mode Operating the SystemSelecting the Source Dim modeVolume Control Sound ControlTo switch off DBB Personal SettingSteps To exit without storing the setting, press Ç Automatic DSC-DBB / VEC-DBB selectionVideo CD DVD-VIDEODVD-Video Audio CDSpeaker Connection Setting up the Multichannel systemMultichannel sound TerminalsSwitching Surround Control Sound Positioning the SpeakersPress Surround Control Display indications Default screenMenu bar/Status window GeneralTurning On the power TV Shape OSD MenuPersonal preferences CountryDigital output Night ModeAccess Control Analog outputDeauthorizing discs Activating/deactivating the child lockAuthorizing discs Activating/Deactivating Parental ControlIf you forget your 4 digit code Loading discsChanging the 4-digit code Parental Control DisclaimerGeneral features Playing a DVDPlaying a VCD DVDs VCDsSpecial DVD-features When PBC OFF Special VCD-FeaturesWhen PBC on Playing an audio CDStoring an FTS Program Switching FTS ON/OFFFTS Favorite Track Selection Erasing a track from an FTS- programFront speakers Channel settingsDelay times Surround speakersLoading the CD Changer Discs for playbackCD Direct Play Playing a CDProgramming Tracks Disc ChangeSelecting a desired track Reviewing the programErasing the program when Tuner Storing Preset StationsTuning to radio stations Automatic programmingAUX/CDR Tuning to Preset Radio StationsThere are two Auxiliary modes Normal AUX mode Selecting External EquipmentClock Setting TimerTimer Setting ClockSleep only on remote control Sleep TimerTo switch off the Timer To switch off the Sleep TimerSpecifications SpecificationsSubject to modification Maintenance Troubleshooting MaintenanceDVD-VIDEO Player Operation CD Player Operation Radio ReceptionGeneral Audio System WHO is COVERED?