Philips FW-D5D manual General Information Safety Information

Page 8

GENERAL INFORMATION

SAFETY INFORMATION

English

General Information

•The typeplate (which contains the serial number) is located at the rear of the system.

•Recording is permissible if copyright or other rights of third parties are not infringed.

•This device complies with the Federal Communications Commission (FCC) rules, part 15 and with 21 CFR 1040.10. Operation is subject to the following two conditions:

–This device may not cause harmful interference, and

–This device must accept any interference received, including interference that may cause undesired operation.

Environmental

Information

All unnecessary packaging has been omitted.We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Energy Star

As an ENERGY STARR Partner, Philips has determined that this product meets the ENERGY STARR guidelines for energy efficiency.

Accessories (Supplied)

–Remote control

–Batteries (two AA size) for remote control

–AM loop antenna

–FM wire antenna

–AC power cord

–CS-05 speaker package (includes one pair of surround speakers and one center speaker)

–CVBS cable cinch

Safety Information

•Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.The typeplate is located at the rear of your system.

•When the system is switched on, do not move it around.

•Place the system on a solid base (e.g. a cabinet).

•Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

•Do not place the system on soft carpet that will cover the ventilation hole at the bottom.

•The system incorporates a built-in safety feature that prevents overheating.

•Do not expose the system to excessive moisture, rain, sand or heat sources.

•Under no circumstances should you repair the system yourself, as this will invalidate the warranty!

•If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD/DVD unit inside the system. Should this occur, the player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

•Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.

•To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

8

pg 01-43/D5/37-Eng

8

7/13/00, 11:50 AM

3139 116 19774

Page 7 Page 9
Image 8
Page 7 Page 9
Contents FW- D5 3139 116Warranty Verification Congratulations on your purchase, and welcome to the family Dear Philips product ownerSet complies with the FCC-Rules, Part 15 and with 21 CFR EnglishEL 4562-E004 99/3 Español Français English IndexClass Laser Product For Customer Use TypeRegion code for this set is DVD-VIDEO General Information Safety Information FM Wire Antenna PreparationRear Connections AM Loop AntennaWireless Surround Out Connection Connecting other equipment to your SystemSpeakers Connection Center Speaker ConnectionAC Power Supply Inserting batteries into the Remote ControlAudio Digital Out Connection Insert the batteries Type R06 orControls Disc Change OpencloseControls on the system and remote control Searchtuning à áCD / CD CD 1 / CD 2 / CD 3 CDË, etc Switching the system on Demonstration modeSwitching the system to standby mode Operating the SystemDim mode Volume ControlSelecting the Source Sound ControlPersonal Setting Steps To exit without storing the setting, press ÇTo switch off DBB Automatic DSC-DBB / VEC-DBB selectionDVD-VIDEO DVD-VideoVideo CD Audio CDSetting up the Multichannel system Multichannel soundSpeaker Connection TerminalsPress Surround Control Switching Surround Control SoundPositioning the Speakers Default screen Menu bar/Status windowDisplay indications GeneralTurning On the power OSD Menu Personal preferencesTV Shape CountryNight Mode Access ControlDigital output Analog outputActivating/deactivating the child lock Authorizing discsDeauthorizing discs Activating/Deactivating Parental ControlLoading discs Changing the 4-digit codeIf you forget your 4 digit code Parental Control DisclaimerPlaying a VCD General featuresPlaying a DVD DVDs VCDsSpecial DVD-features Special VCD-Features When PBC onWhen PBC OFF Playing an audio CDSwitching FTS ON/OFF FTS Favorite Track SelectionStoring an FTS Program Erasing a track from an FTS- programChannel settings Delay timesFront speakers Surround speakersDiscs for playback CD Direct PlayLoading the CD Changer Playing a CDDisc Change Selecting a desired trackProgramming Tracks Reviewing the programErasing the program when Storing Preset Stations Tuning to radio stationsTuner Automatic programmingTuning to Preset Radio Stations There are two Auxiliary modes Normal AUX modeAUX/CDR Selecting External EquipmentTimer Timer SettingClock Setting ClockSleep Timer To switch off the TimerSleep only on remote control To switch off the Sleep TimerSubject to modification SpecificationsSpecifications DVD-VIDEO Player Operation Maintenance TroubleshootingMaintenance General CD Player OperationRadio Reception Audio System WHO is COVERED?
Top Page Image Contents