Hitachi 51G500, 51F500, 57G500 Using the Remote to Control DVD Functions, Precoded DVD Buttons

Page 30

USING THE REMOTE TO CONTROL

DVD FUNCTIONS

Operating the precoded function for your DVD player.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player. (refer to page 31 for pre-codes)

1.Turn ON your DVD player.

2.Aim the remote control at the front of your DVD player.

3.Press and release the DVD/VCR button to switch to DVD pre-coded mode.

4.Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 31.

5.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset code.

6.The remote will now control your DVD player.

NOTES:

1.If your DVD player cannot be operated after performing the above procedures, your DVD player’s code has not been precoded into the remote.

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

	POWER
TV	CBL/SAT DVD/VCR
PIP	SWAP PIP MODE
PIP	FREEZE
	PIP CH
VIDEO	MENU
	SELECT
MUTE	LAST CH
	EXIT

VOL CH

DVD/VCR Button

This button allows the remote to control your DVD player by setting it to DVD mode.

PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

1 2 3

4 5 6

7 8 9

ANT 0 INFO

VID1	VID2	VID3	VID4
REC		ASPECT VIRTUAL HD
	VID5

CLU-4321UG

MY DVD PLAYER CODE IS:

NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.

30

Image 30

Contents Important Safety Instructions First Time USE Remote Control ON-SCREEN DisplayUseful Information Index Safety Points YOU should Know about Your Hitachi Television Prevention of Screen Burn Public Viewing of Copyrighted MaterialAccessories Remote ControlLocation HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Input Jacks Input Front Panel ControlsMagic Focus IR ReceiverFront Panel Jacks and Connectors Rear Panel Jacks Monitor OUTComponent Y-PBPRInputs DVI-HDTV Input InputTypical FULL-FEATURE Setup Rear Panel ConnectionsTips on Rear Panel Connections Connecting External Audio Sources Rear Panel of TelevisionConnecting External Video Sources Before Operating External Video SourceConnecting a Monaural Audio Source to INPUT2~INPUT5 Connecting a Stereo Source to INPUT2~INPUT5 Connecting AN S-VIDEO Source to Input 3, 4 VHS Connecting a Component Source to Input 1 or 2 Y-PBPR DVD PlayerTV or VCR/DVD Buttons Video button HOW to USE the Remote to Control Your TVPICTURE-IN-PICTURE buttons SELECT, MENU, Cursor buttonsAntenna button VOLUME, Mute buttonChannel selector buttons VID1 ~ VID5Aspect button StandardExit button Virtual HD buttonInfo button Last Channel Last CH buttonPOP Mode PICTURE-IN-PICTURE PICTURE-IN-PICTURE PIPPIP button PIP Mode button Split Mode PICTURE-IN-PICTURESurf Mode PICTURE-IN-PICTURE Swap button POP SUB Freeze with PIP OFF Freeze button With PIP on Freeze button with PIP OFF Split FREEZEwith PIP OFFDVD/VCR Button Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Precoded VCR ButtonsUsing the Remote to Control CABLE/SATELLITE BOX Functions Cable CBL/SAT buttonPrecoded CABLE/SATELLITE BOX buttons Using the Remote to Control DVD Functions Operating the precoded function for your DVD playerPrecoded DVD Buttons CABLE, SATELLITE, VCR and DVD Codes for Remote Control Cable Brand CodeON-SCREEN Display OSD Video Audio Channel Manager Locks Setup Picture Mode Movie Mode 32 Pulldown Detection Special FeatureVideo Contrast Brightness Color Tint Sharpness Vertical Position Auto Digital Convergence Adjustment Magic FocusTo Change the Color of Adjustment Point Manual Convergence Adjustment ModeTo Move Adjustment Point To Adjust the ConvergenceAdvanced Settings Color SystemBass AudioTreble BalanceSound Enhancement TechnologyAudio Source Auto Noise CancelPerfect Volume AudioChannel Manager ScanChannel ID Locks LocksMovie Ratings TV Ratings Canadian Ratings English Chart Canadian Ratings EngProgramming is not suitable for children Canadian Ratings French ChartCanadian Ratings Frn Programming restricted to adults ContainsSetup Menu PreferenceSet Menu Background Set The ClockSet The Channels Reception BandAuto Channel Scan Set The Inputs Video 2 Auto Link Video2 Auto LinkSet Event Timer Please Set Clock FirstClosed Caption ChannelAbout Your TV Care of Your Hitachi Television Your Remote Control Do notReception Problems Symptoms Useful InfoDimensions 51F500 57F500 46F500 51G500 57G500 InputsOutputs Hitachi Home Electronics DivisionDigital Media Division Page QR54411