Hitachi 51F520 Read before operating equipment, Prevention of Screen Burn

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

Follow all warnings and instructions marked on this television.

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or ground- ing-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched par- ticularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use the attachments/accessories specified by the man- ufacturer.

12.

Use only with the cart, stand, tripod, brack-

 

et, or table specified by the manufacturer,

 

or sold with the apparatus. When a cart is

used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Televisions are designed to comply with the recommended safety standards for tilt and stability.

Do not apply excessive pulling force to the front, or top, of the cabinet which could cause the product to overturn resulting in product damage and/or personal injury.

16.Follow instructions for wall, shelf or ceiling mounting as rec- ommended by the manufacturer.

17.An outdoor antenna should not be located in the vicinity of overhead power lines or other electrical circuits.

18.If an outside antenna is connected to the receiver be sure the antenna system is grounded so as to provide some protec- tion against voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper ground- ing for the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿

￿￿￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Note to the CATV system installer: This reminder is provid- ed to call the CATV system installer’s attention to Article 820- 40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Do not place any objects on the top of the television which may fall or cause a child to climb to retrieve the objects.

Projection TV’s are heavy and can mark or damage floor surfaces (especially wood flooring) if moved improperly. Do not slide or force TV into position. Always roll TV allowing casters at bottom of unit to help steer and position the TV.

PREVENTION OF SCREEN BURN

This Wide Screen TV is designed to display wide screen pictures. Images should be viewed mostly in wide screen format or zoomed to fit the screen with moving pictures. Use of side panels, top and bottom panels of standard picture formats should only be 15% of your total viewing time to prevent uneven aging of the phosphors. Phosphors in the lighted area of the picture will age more rapidly than the gray areas. Continuous on-screen displays such as video games, stock market quotations, computer generated graphics, and other fixed (non-moving) patterns can cause permanent damage to television receivers. Such “SCREEN BURNS” constitute misuse and are NOT COVERED by your HITACHI Factory Warranty.

PUBLIC VIEWING OF COPYRIGHTED MATERIAL

Public viewing of programs broadcast by TV stations and cable companies, as well as programs from other sources, may require prior authorization from the broadcaster or owner of the video program material.

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited consumer uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

This product contains lead. Dispose of this product in accordance with applicable environmental laws. For prod- uct recycling and disposal information, contact your local government agency or the Electronic Industries Alliance at www.eiae.org (in the US) or the Electronic Product Stewardship Canada at www.epsc.ca (in Canada). For more information, call 1-800-HITACHI.

3

Image 3
Contents Index Operating Guide for 51F520, 57F520Safety Points YOU should Know about Your Hitachi Television Important Safety InstructionsRead before operating equipment Prevention of Screen BurnPublic Viewing of Copyrighted Material First AccessoriesHOW to SET UP Your NEW Hitachi Projection TV Antenna Connections to Rear Jack Panel HOOK-UP Cables and ConnectorsIR Receiver Front Panel ControlsMagic Focus Front Input Jacks InputFront Panel Jacks and Connectors Monitor OUT Rear Panel JacksRS232C Input HDMI1 High Definition Multimedia Interface InputRear Panel Connections Typical FULL-FEATURE SetupTips on Rear Panel Connections Rear Panel of Television Connecting External Audio SourcesConnecting External Video Sources Connecting a Monaural Audio Source to INPUT1~INPUT5Before Operating External Video Source Connecting a Stereo Source to INPUT1~INPUT5 Connecting AN S-VIDEO Source to Input 3, 4 HDMI-HDMI Connecting a Component Source to Input 1 or 2 Y-PBPR Remote Control Pause button HOW to USE the Remote to Control Your TVPower button Mode buttonsStandard Aspect buttonAnt B Ant a Input Inputs buttonVideo Last Channel LC button Volume VOL, Mute buttonChannel SELECTOR/FAVORITE Channel FAV CH buttons Dash buttonPOP Mode PICTURE-IN-PICTURE PICTURE-IN-PICTURE PIPPIP button PICTURE-IN-PICTURE PIP Modes PIP Mode PICTURE-IN-PICTURESplit Mode PICTURE-IN-PICTURE Surf Mode PICTURE-IN-PICTUREMain Freeze Split FreezeStrobe Freeze Precoded Cable BOX buttons Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Cable CBL buttonPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons SAT Set-Top-Box/Satellite buttonPrecoded DVD Buttons Using the Remote to Control DVD FunctionsOperating the precoded function for your DVD player DVD buttonPrecoded VCR Buttons HOW to USE the Remote to Control VCR FunctionsOperating the precoded function for your VCR VCR buttonVCR BRAND. . . . . . . . . . . . . Code VCR, CABLE, SATELLITE, and DVD Codes for Remote ControlON-SCREEN Display OSD Audio Channel Video Picture ModeContrast Video Reset Video SettingsNoise Reduction Auto Movie Mode Color DecodingAuto Color Audio Treble Bass BalanceBBE Technology Auto Noise Cancel Perfect Volume Loudness Audio SourceInternal Speakers Vertical Position AspectMode Auto AspectChannel Manager Chan. ManagerReception Band Auto Channel Scan Scan Channel ListChannel ID Locks Movie Ratings TV Ratings Canadian Ratings English Table Canadian Ratings EngFrn Canadian RatingsSet The Clock TimersSet Day/Night Timer Set Sleep TimerSet Event Timer Setup Magic Focus Tune Up Auto Digital Convergence AdjustmentTo Move Adjustment Point To Change the Color of Adjustment PointTo Adjust the Convergence Display Menu Preference Menu PreferenceSet The Inputs Set The Menu BackgroundVideo2 Video 2 Auto LinkSet Black Side Panel Set Virtual HDChannel Set Closed CaptionSet AV Control Set Monitor OutAbout Your TV Do not Care of Your Hitachi Television Your Remote ControlIgnition Noise Reception ProblemsUseful Info SymptomsDimensions 51F520 57F520 InputsOutputs Home Electronics Division Dial Toll FreeDigital Media Division Step DISASSEMBLY/ASSEMBLY InstructionsSeparation Procedure RE-ASSEMBLY Procedure Index Page Page Page Page QR64451