Hitachi 51F520 important safety instructions RE-ASSEMBLY Procedure

57” DISASSEMBLY/ASSEMBLY INSTRUCTIONS

2 - RE-ASSEMBLY PROCEDURE

STEP 8

To re-assemble the set, lift the top portion and align onto the bottom cabinet. Gently lower the top portion until it sits flush on the bottom.

STEP 9

Re-install the joint connector bolts (4 pcs.) that were removed in step 5 of the disassembly.

STEP 10

(a)

Re-install the top (4) four screws into the lower rear cover, see (a). Re-install the (4) four side screws that hold the back cover to the cabinet, see

(b).

(b)

STEP 11

(a)

Re-connect the sensor connector to the sensor board, see (a). Re-install the sensor box, see (b).

(b)

STEP 12

(a)

Re-install 4 screws ( , ,￿, ) that hold the screen frame to the cabinet on the Right side, see (a) and (b). Repeat to re-install 4 screws on the Left side.

(b)

Please re-install 3 screws

STEP 13 ( , ,￿) below screen frame that hold the back cover to the cabinet as the arrows shows.

(a)Left Side

Please re-install 3 screws

( , ,￿) below screen frame that hold the back cover to the cabinet as the arrows shows.

(b)Right Side

STEP 14

Re-install both of the front decoration panels, see (a) and (b).. Re-install the speaker grille, aligning it with the bottom cabinet, see (c). This com- pletes the Disassembly and Assembly instructions.

(a)

(b)

(c)

74