Hitachi 53SBX10B manual Prevention of Pattern Burn, Public Viewing of Copyrighted Material

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

Follow all warnings and instructions marked on this television.

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use the attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the

apparatus. When a cart is used, use

caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Do not place any objects on the top of the television which may fall or cause a child to climb to retrieve the objects.

15.Televisions are designed to comply with the recommended safety standards for tilt and stability. Do not apply excessive pulling force to the front, or top, of the cabinet which could cause the product to overturn resulting in product damage and/or personal injury.

16.Follow instructions for wall, shelf or ceiling mounting as recommended by the manufacturer.

17.An outdoor antenna should not be located in the vicinity of overhead power lines or other electrical circuits.

18.If an outside antenna is connected to the receiver be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding for the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿

￿￿￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Note to the CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Disposal of this product may require specific instructions pertaining to your resident state. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.

PREVENTION OF PATTERN BURN

Continuous on-screen displays such as video games, stock market quotations, computer generated graphics, and other fixed (non- moving) patterns can cause permanent damage to television receivers. Such PATTERN BURNS constitute misuse and are NOT COVERED by your HITACHI Factory Warranty. When using the Picture-in-Picture function, the sub-picture should not be left permanently in one corner of the screen or a PATTERN BURN may develop over a long period of time.

PUBLIC VIEWING OF COPYRIGHTED MATERIAL

Public viewing of programs broadcast by TV stations and cable companies, as well as programs from other sources, may require prior authorization from the broadcaster or owner of the video program material.

3

Image 3
Contents 53SBX10B Safety Points YOU should Know about Your Hitachi Television Important Safety InstructionsPublic Viewing of Copyrighted Material Prevention of Pattern BurnVOL AccessoriesViewing HOW to SET UP Your NEW Hitachi Projection TVAntenna LocationAntenna Connections to Rear Jack Panel HOOK-UP Cables and ConnectorsFront Panel Controls Magic Focus Power lightRemote Control sensor Perfect Picture sensorInput Output Front Panel Jacks and ConnectionsMonitor OUT Rear Panel JacksComponent Y-PBPRInputs Rear Panel Connections Typical FULL-FEATURE SetupTips on Rear Panel Connections Tips on Rear Panel ConnectionsConnecting External Audio Amplifier Connecting External Audio SourcesBefore Operating External Video Source Connecting External Video SourcesVCR VCR or Laserdisc Player Hitachi Model or Similar Model Back Connecting a Component Source to Video 4 Y-PBPRLight Button Genius Remote ControlHOW to USE the Genius Remote to Control Your TV Cable CBLSET-TOP-BOX STB Last Channel Last CH button AV1, AV2, AV3, or CD, TAPE, AMP buttonsChannel selector buttons Sleep buttonPICTURE-IN-PICTURE buttons VOLUME, Mute buttonThumb STICK/SELECT button Status buttonSingle Mode PIP PICTURE-IN-PICTURE PIPPIP button Single PICTURE-IN-PICTURE Surf Mode PIPPIP Mode button Swap buttonStrobe Freeze Freeze button With PIP onFreeze button With PIP OFF Single FreezeExclusive TV Buttons Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Precoded VCR ButtonsPrecoded Cable BOX buttons Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Cable CBL buttonPrecoded SET-TOP-BOX buttons SET-TOP-BOX STB buttonUsing the Remote to Control DVD Functions Operating the precoded function for your DVD playerPrecoded DVD Buttons Precoded AUDIO/VIDEO Buttons AV1, AV2, AV3 ButtonsVCR BRAND. . . . . . . . . . . . . . . . . Code AUDIO/VIDEO CodesUltratec OSD Setup Customize Video Audio Menu Language SET UPMenu To Menu Bar To Quit I t Signal SourceAuto Channel SET Erase Channel MemoryChannel List Clock SET Magic Focus Channel ID CustomVideo ID Family Favorites Menu Family Favorites Operation Customize Use number buttons to enter Parental ControlMenu To Menu Bar To Quit Event ProgAuto Link Channel Closed CaptionDisplay ModeVideo Contrast Brightness Color Tint Sharpness ResetAuto Color Advanced SettingsColor Temperature Perfect PictureBalance AudioBass TrebleInternal Speakers MTS ModeAuto Noise Cancel Perfect VolumeTheater Modes TheaterSurround OFF SurroundDo not Care of Your Hitachi Projection TV Your Remote Control¥ Ignition Noise Reception ProblemsUseful Info SymptomsFeatures SpecificationHome Electronics Division HitachiQR47651