Hitachi 43FDX11B AV1, AV2, AV3, or CD, TAPE, AMP buttons, Channel selector buttons, Sleep button

Page 22

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV

AV1, AV2, AV3, or CD, TAPE, AMP buttons

When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (see page 31)

NOTE:

Your remote control SOURCE WIZARD buttons are either labeled as AV1, AV2 and AV3, or

CD, TAPE, and AMP.

 

If your remote control SOURCE WIZARD buttons are labeled as AV1, AV2, and AV3, please program your Audio/Video

 

components as follow for best performance. Use AV1 to program your CD brand. Use AV2

to program your TAPE

 

brand, and use AV3 to program your AMPLIFIER/RECEIVER brand.

 

AV1-Use for CD brand AV2-Use for TAPE brand

AV3-Use for AMPLIFIER/RECEIVER brand.

SOURCE WIZARD

AV1

AV2

DVD

AV3

CHANNEL selector buttons

CHANNEL selector buttons are used to set FAVORITE CHANNELS, CHANNEL MEMORY, etc.

Enter one, two, or three numbers to select channels. Enter 0 first for channels 1 to 9, or simply press the single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the 1 button, wait until two dashes appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.

Channel selection may also be performed by pressing CH up ( ) or down ( ).

NOTE: The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode. (see page 37)

SLEEP button

Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15 minutes to this timer, up to a maximum of three hours. Once set, use STATUS when you want to view time remaining. If the SLEEP button is pressed while the timer is set, it will reset to the original condition.

LAST CHANNEL (LAST CH) button

Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)

Ant A 10

LAST CH

Ant A 39

ANTENNA button

The ANT button will select between Antenna A and Antenna B each time the button is pressed.

Ant A 10

ANT

Ant B 28

C.C. button

Press this button to quickly turn the Closed Caption feature on, off and auto (see page 52 for more information).

HELP button

Press this button when a menu is displayed to view HELP text, which gives a description of the displayed menu. The HELP text will be displayed every time a MENU is displayed, until this button is pressed again.

ASPECT button

Press this button to quickly change the PICTURE FORMATS aspect ratio. (See page 44 for more information)

PIX or MODE button

Press this button repeatedly to direct access THEATER MODE between Sport, News, Movie, and Music.

MENU button

The MENU button will start the On-Screen Display.

EXIT button

When in MENU mode, this button will exit all On-Screen Displays.

22

Image 22
Contents 53UDX10B 61UDX10B 43FDX11B 43FDX10B Power Source Safety Points YOU should Know about Safety TipsYour Hitachi Projection Television Picture Cautions Television AccessoriesOptional Custom Hitachi Television Stand Location HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Perfect Picture sensor Power lightRemote Control sensor Front Input Jacks for VideoFront Panel Jacks and Connections Input OutputRear Panel Jacks Monitor OUTComponent Y-PBPRInputs Typical FULL-FEATURE Setup Rear Panel ConnectionsTips on Rear Panel Connections Tips on Rear Panel ConnectionsConnecting External Audio Sources Connecting External Audio AmplifierConnecting External Video Sources VCRVCR Connecting AN S-VIDEO Source to Input 1, 2 Connecting a Component Source to Video 4 or 5 Y-PBPR DVD PlayerGenius Remote Control Light ButtonCable CBL HOW to USE the Genius Remote to Control Your TVSET-TOP-BOX STB Channel selector buttons PIX or Mode buttonAV1, AV2, AV3, or CD, TAPE, AMP buttons Sleep buttonStatus button VOLUME, Mute buttonThumb STICK/SELECT button PICTURE-IN-PICTURE buttonsPICTURE-IN-PICTURE PIP Single Mode PIPPIP button Swap button PICTURE-IN-PICTURE Surf Mode PIPPIP Mode button SingleSingle Freeze Freeze button With PIP onFreeze button With PIP OFF Strobe FREEZEwith PIP offPrecoded VCR Buttons Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Exclusive TV ButtonsCable CBL button Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsSET-TOP-BOX STB button Precoded SET-TOP-BOX/SATELLITE Receiver buttonsOperating the precoded function for your DVD player Using the Remote to Control DVD FunctionsPrecoded DVD Buttons AV1, AV2, AV3 Buttons Precoded AUDIO/VIDEO ButtonsAUDIO/VIDEO Codes VCR BRAND. . . . . . . . . . . . . . . . . CodeUltratec OSD Setup Customize Video Audio Theater Thumb SET UPSET Menu Language StickPlug & Play Thumb StickSET ANTENNA/CABLE Set Antenna/CableSET Channel Memory Edit Channel Memory View Channel List SET the Clock Magic Focus Model 43FDX10B/43FDX11B Please see Digital Array onDigital Array Model 43FDX10B/43FDX11BThumb Thumb Stickstick Picture FormatsPosition Signal Picture FormatsVideo Display Comp Color TypeVIDEO5 Customize Name the ChannelName the Inputs Name the InputsSET Favorite Channels Favorite Channels Operation SET Parental Locks StickSET Program Timer StickVideo Input Sensor Mode Closed CaptionDisplay ChannelContrast Brightness Color Tint Sharpness Reset VideoPerfect Picture Advanced SettingsColor Temperature Auto ColorTreble AudioBass BalancePerfect Volume MTS ModeAuto Noise Cancel Internal SpeakersTheater Theater ModesSurround OFF SurroundTechnology Care of Your Hitachi Projection TV Your Remote Control Do not¥ Ghosts Reception Problems¥ Ignition Noise ¥ SnowSymptoms Useful InfoOutputs ¥ Component Video Y-PB/PRInputs 43FDX10B 53UDX10B 61UDX10B 43FDX11BHitachi Home Electronics DivisionPage Page QR48504