One for All URC 8800 manual Learning Functions Onto the 1L Through 6L Keys

32

LEARNING FUNCTIONS ONTO THE 1L THROUGH 6L KEYS

The 1L, 2L, 3L, 4L, 5L, and 6L keys can be used to customize those functions that are unique to your home entertainment needs. For example, the

a/v Producer does not offer Tracking Up or Down for a VCR. However, with the learning feature, you can add these as well as many other functions to the a/v Producer.

NOTE: Please have your original remote controls handy before performing learning.

1 (Device Key) Press and release the Device key (e.g., VCR) where you want a/v Producer to learn new feature(s).

2	Press and hold SETUP until the
	display screen changes from the
	device you selected [e.g., VCR and
	the TIME] to [TIMED SEQ].

3x 2 Press MENU – twice, the display will change to [CONFIGURE]. Press SELECT, the display will change to [THEATR SEL]. Press MENU + twice, the display will

x 2 change to [IR LEARNER].

4x 2 Press SELECT, the display screen will change to [IR LEARN]. Press SELECT again.

5	The display screen will change from
	[IR LEARN] to [VCR].

a/v Producer is now ready to learn new features.

NOTE: At this point, you can press a different device key (e.g.,TV) to learn features in a different mode.

6 (Device Key) Press and release the Device key (e.g., TV) in which you would like to learn your new function.

	33
7	Press and release the (1~6)L key
	where you want to assign a compo-
	nent’s feature. The a/v Producer’s
	red light will flash rapidly.
8	Place your original remote control
	about 2 inches apart (nose-to-nose)
	from the a/v Producer.
	2"

NOTE: If the a/v Producer has trouble learning a feature, try mov- ing your original remote control to the left or right during the learning process.The position of the IR LED transmitter on your original remote control may be offset.

9	On your original remote control,
	press and hold the key (feature) you
	want learned until the red light on
	the a/v Producer blinks twice and
	the display will read [SUCCESS}. If
	the red light on the a/v Producer
	does not blink twice or the display
	reads [ERROR], stop and repeat
	step 7 to 9.

NOTE: You can now repeat steps 6 through 9 to learn additional functions on the other (1~6) L keys and in different modes.

10	Once the a/v Producer has learned
	all desired features, press and
	release ESC to exit out of learning
	mode.
11	To test a new feature, press and
	release a desired device key, fol-
	lowed by the (1~ 6) L key where a
	corresponding feature was learned.

NOTE: Steps 7 through 9 need to be completed within

10 seconds. Please read the next three steps before proceeding.