One for All URC 8800 Setting the Clock, Keys are not mode specific, Pip, Rew, Play, Ff, Stop

6

Feature Function

The CH + (Channel Up) and CH – (Channel Down) keys change channels the same as the Channel Up and Down keys on your original remote.

The MACRO and MACRO2 keys memorize up to 15 keystrokes that can be accessed in sequence at the press of a single key. These

keys are not mode specific.

The SHIFT key accesses advanced features that are mapped under the following keys: CENTER, MENU,

SELECT, MUTE, PREV CH,

PIP, REW, PLAY, FF, STOP, and

PAUSE.

The 1L ~ 6L keys are used for learning new features onto the a/v Producer. See pages 32 to 33 for further details.

NOTE: For a detailed explanation of what function each key will perform by device type (e.g.,TV, VCR, CBL/SAT,etc.), please refer to pages 49 through 61.

7

SETTING THE CLOCK

To set up the CLOCK/TIME on the display screen:

1	Press and hold SETUP until the
	display screen changes from
	[DEVICE and the TIME] to
	[TIMED SEQ].

2x 2 Press the MENU – key twice, the display will change to [CONFIGURE]. Press SELECT, the display will

change to [THEATR SEL].

3	Press MENU – one time, the display
	will change to [TIME SETUP].
	Press SELECT again.

4 0 - 9 The display will change to [TIME] and the first digit in the time will blink. Enter either a 0 or a 1, then the next digit in the time will begin to blink, continue entering the time until all four digits of the time have been set.

5	After the time has been set, AM/PM
	will then blink. Press MENU – to
	toggle between AM and PM, once
	AM or PM is selected, press
	SELECT.
6	The display will then change to the
	day of the week (i.e., MON, TUE,
	WED, THU, FRI, SAT or SUN). Use
	MENU – to toggle through the days
	until the proper day of the week is
	displayed on the screen, then press
	SELECT. The display will return to
	the [DEVICE and the TIME] screen
	with the correct time on the display.

NOTE: After changing the batteries, you will have to reprogram the clock.