One for All URC-6131 manual RE-ASSIGNING Device Keys, Restoring All Keymoved Keys In a Single Mode

OFA 6 PVR 2/15/03 9:25 AM Page 15

Restoring All Keymoved Keys In A Single Mode

1. Press and hold SET until the LED (red light)

blinks twice, then release SET.

2. Enter 9 - 9 - 4. The LED will blink twice.

3.Press the destination mode twice (where keymoved keys are stored). The LED will blink twice.

RE-ASSIGNING DEVICE KEYS

The One For All 6-Device PVR Universal Remote Control can be set to control a second TV, PVR,VCR, DVD player, or other device. For example, to control a TV, a cable box, and two VCRs, you will need to re-assign the unused DVD key to operate the second VCR as follows:

1. On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET.

2. Enter 9 - 9 - 2. The LED will blink twice.

3. Press VCR once, then press DVD once. The LED will blink twice.

4. The DVD key is now ready to be programmed for your second VCR. See Programming Device Control on page 9.

To re-assign other device keys to the DVD key, repeat steps 1 through 4 with a sequence from the below chart:

NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign Device	Perform Sequence
DVD as 2nd TV key:	SET - 9	- 9	- 2	- TV - DVD
DVD as 2nd CBL/SAT key:	SET - 9	- 9	- 2	- CBL/SAT - DVD
DVD as 2nd PVR key:	SET - 9	- 9	- 2	- PVR - DVD
DVD as 2nd AUD key:	SET - 9	- 9	- 2	- AUD - DVD

You can also re-assign another unused device key by substituting it for the DVD key above and performing the sequence. For example, to re-assign an unused AUD key as a second VCR key, perform SET - 9 - 9 - 2 - VCR - AUD. When a re-assignment is done, the LED will blink twice to confirm your choice.At that time, you will need to program the remote control for the new device (see Programming Device Control on page 9).

15