One for All URC-7040 manual Installing the Batteries, Features and Functions

Page 4

Installing the Batteries

Your ONE FOR ALL 4 Remote needs 2 new "AA/LR6" Alkaline batteries.

1Remove the battery cover from the back of your ONE FOR ALL 4 by pressing down on the arrow on the battery cover and sliding it backwards.

2Match the batteries to the + and – marks inside the battery case, then insert the batteries.

3Slide the battery cover back into place until it clicks. Make sure the battery cover is secure.

Important notes:

-In order to avoid having to re-program your ONE FOR ALL 4 after you remove the batteries, you will need to insert new batteries within 5 minutes. Also it is recommended that you do not use rechargeable batteries.

-On the inside of the battery compartment door you will find a label on which to write your Set-Up Codes for future reference. This you will do after setting up your ONE FOR ALL 4 remote for your devices.

Features and Functions

Please refer to the picture of the ONE FOR ALL 4 Remote Control on Page 3.

1Power Key:

The Power key controls the same function as it did on your original remote.

2Device Keys:

3

4

5

6

The TV, VCR, DVD & SAT keys select the home entertainment device you wish to control. For example, pressing the TV key allows the remote to control the functions of your television, etc.

4 Mode Indicator LED’s:

During the use of your ONE FOR ALL 4, these LED’s will indicate the mode you’re using. For example when you are controlling your DVD player, the LED on the DVD key will flash red.

Number Keys:

The Number keys (0-9, -/--(10), AV (20)) provide the functions just like your original remote, such as the direct access to programme/channel selection. If your original remote uses a 10 key, this function can be found by pressing the -/-- key. If your original remote uses a 20 key, this function can be found by pressing the AV key.

Menu Key:

Controls the same function as it did on your original remote control.

Magic Key:

7

8

The Magic key is used to set-up your ONE FOR ALL 4 Remote Control and to access special functions.

Exit Key:

The Exit key will exit the Menu.

Menu Navigator:

The Menu Navigator is a miniature joystick. The movement of the navigator up, down, left and right operates the same functions as the up, down, left and right keys of your original remote. By pressing the Menu Navigator, it will operate the same function as the OK/Select key on your original remote control. These keys will allow you to navigate up, down, left and right through the menu of your device.

Please note: the Menu Navigator Joystick is not guaranteed against abusive use such as in on-line gaming now offered by Satellite/Cable Service Providers.

WWW.ONEFORALL.COM

4

Image 4
Contents URC-7040 Table of Contents About Your ONE for ALLPage Installing the Batteries Features and FunctionsVolume Up / Down Control Channel Up / Down ControlRecall Key Mute KeyInstallation Setting Up Your DevicesDevices can be found under the following keys SATNow slowly, alternate between TV and POWER, over Search MethodExample To search for your television code Press 9 9 1. The red light will blink twiceQuick Code Reference Changing the Mode of a Device Key Example to reset the SAT key back to its original modeAdvanced Features Volume Punch ThroughColour and Brightness Auto ScanDevice Sleeptimer ONE for ALL SleeptimerInstalling the ONE for ALL Sleeptimer To activate the ONE for ALL SleeptimerTrouble-Shooting ONE for ALL Recall Previous ChannelCustomer Service 3210805Ireland Australia South AfricaAGB ASAAWA BPLDER DTSELG ESCITV JVCKTV LXIRCA RFTSBR SEGTEC TMKCatron 0020 TVA AGSAslf ASTCNT DNRDNT DSTOsat SCSSKR StviJMB 3DLABREC URC-7040 Printed on Recycled Paper Garantie
Related manuals
Manual 24 pages 4.35 Kb